DeWalt DW100-220 Chuck Key Holder, Chuck Removal, Chuck Installation, Lubrication, Accessories

your skin, rinse thoroughly with water. If any liquid gets in your eyes, rinse thoroughly with water and call a physician immediately.

bit about 3/4" into chuck. Tighten chuck collar by hand. Place chuck key in each of the three holes, and tighten in clockwise direction. It’s important to tighten chuck with all three holes. To release bit, turn chuck counter clockwise in just one hole, then loosen the chuck by hand.

Chuck Key Holder

(May be installed already.)

1.Push double-hole end of holder through the slot in other end of holder (Figure 4.)

2.Slip loop over electric plug and draw loop tight around cord (Figure 5.)

3.Push ends of Chuck Key Handle through two holes in end of holder (Figure 6.)

Chuck Removal

Place chuck key in any one of the three holes in the chuck, as shown in Figure 7. Strike the key sharply in the counterclockwise direction (when viewed from the front of the tool). This will loosen the chuck so that it can be removed by hand.

Chuck Installation

Screw the chuck on by hand as far as it will go. Place the chuck key in any of the three holes in the chuck and strike it sharply in the clockwise direction (when viewed from the front of the tool) as shown in Figure 8. (145-160 in. lbs. of torque is recommended.)

4

FIG. 5

FIG. 4

FIG. 6

Lubrication

When the tool is taken apart for motor brush replacement a small amount of grease should be added (or redistributed from that remaining in housing) to the gears.

The ball bearings used in this tool are lubricated during manufacture and require no lubrication.

Accessories

Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center. If you need assistance in locating any accessory for your tool, please contact your local dealer or authorized service center.

If you need assistance in locating any accessory, please contact DEWALT Industrial Tool Company, P.O. Box 158, 626 Hanover Pike, Hampstead, MD 21074 or call 1-800-433-9258.