Remington 500V operating instructions Head Shank Plastic Flute

Page 11

Safety Precautions

G018

6.Power fasteners are a permanently installed fixture. An act of demolition is required for their removal. Appropriate safety precautions must be taken.

Head

Shank

Plastic Flute

7.Never use common nails or other materials as fasteners. Remington® Power Fasteners are manufactured from special steel and heat treated to produce a very hard yet ductile fastener.

G018

8.Never pry a power load out of the strip. Prying can discharge the load causing serious injury (See Troubleshooting Guide, page 26). Never attempt to reload used strips.

9.If work is interrupted for any reason, remove the power load strip before removing the power fastener.

106763

11

Image 11

Contents Model Index Before Using Handling the Tool Safety PrecautionsPowd Load Powder Loads ? ? Know Your Fastening Base MaterialNever make fastenings in spalled or cracked areas Operating the Tool Power Loads and Fasteners Never use power loads in firearms Head Shank Plastic Flute WHY a Power Fastener Holds Steel Why a Power Fastener HoldsWHY a Power Fastener Holds Concrete Fastening Into Steel Power Loads and Power Indicator SettingOverdriven Power Fasteners and Piston Fastening Into ConcreteOperation Water 500V Parts ListCleaning and Maintenance Removing Barrel Assembly Tool DisassemblyRemoving Rocker ARM Assembly Removing Handle PAD AssemblyRemoving Rear PAD and Power Indicator Assembly Removing Firing PIN Removing Trigger and Pawl AssemblyInserting Outer Liner Assembly Tool AssemblyRemoving Baffle Assembly Removing Outer Liner Assembly from HousingReplacing Advance BAR Inserting Baffle AssemblyReplacing Trigger and Pawl Assembly Replacing Firing PIN Replacing Rocker ARM AssemblyAssembling Barrel Assembly Attaching Rear PAD AssemblyAttaching Handle PAD Assembly Replacing Key Stop Problem Possible Cause Remedy Troubleshooting GuideWarranty Service Replacement Parts And AccessoriesTechnical Service Repair ServiceFasteners Parts CentralsPower load and power fastener application information Application Chart106763 106763 A. only Limited Warranty Agreement