Remington 500V operating instructions Attaching Rear PAD Assembly, Attaching Handle PAD Assembly

Page 24

Tool Assembly (Cont.)

G. ATTACHING REAR PAD ASSEMBLY

1.Push the rear pad and power indicator assembly onto housing, aligning screws with holes in housing.

2.Holding pressure on rear pad and indicator assembly, tighten screws with 3mm hex wrench. Note: Rear pad and power indicator assembly is spring loaded. Pressure should be kept on the assembly at all times while tightening screws to avoid loosing parts.

Screws

Housing

Rear Pad and Power Indicator Assembly

Figure 21 - Attaching Rear Pad and Power Indicator Assembly

H. ATTACHING HANDLE PAD ASSEMBLY

1.Place handle pad assembly onto housing body and tighten screw with 3mm hex wrench. Make sure rocker arm spring stays tight against the handle pad assembly while tightening screw.

Rocker Arm

Spring

Handle Pad

Assembly

3mm Hex Wrench

Figure 22 - Attaching Handle Pad Assembly

I. ASSEMBLING BARREL ASSEMBLY

1.Using moderate force, insert piston assembly into barrel (see Figure 23).

Piston

Assembly

Barrel

Figure 23 - Inserting Piston Assembly into Barrel

106763

24

Image 24

Contents Model Index Before Using Safety Precautions Handling the ToolPowd Load Powder Loads Know Your Fastening Base Material ? ?Never make fastenings in spalled or cracked areas Operating the Tool Power Loads and Fasteners Never use power loads in firearms Head Shank Plastic Flute Why a Power Fastener Holds WHY a Power Fastener Holds ConcreteWHY a Power Fastener Holds Steel Power Loads and Power Indicator Setting Overdriven Power Fasteners and PistonFastening Into Concrete Fastening Into SteelOperation Water Parts List 500VCleaning and Maintenance Tool Disassembly Removing Barrel AssemblyRemoving Handle PAD Assembly Removing Rear PAD and Power Indicator AssemblyRemoving Rocker ARM Assembly Removing Trigger and Pawl Assembly Removing Firing PINTool Assembly Removing Baffle AssemblyRemoving Outer Liner Assembly from Housing Inserting Outer Liner AssemblyInserting Baffle Assembly Replacing Trigger and Pawl AssemblyReplacing Advance BAR Replacing Rocker ARM Assembly Replacing Firing PINAttaching Rear PAD Assembly Attaching Handle PAD AssemblyAssembling Barrel Assembly Replacing Key Stop Troubleshooting Guide Problem Possible Cause RemedyReplacement Parts And Accessories Technical ServiceRepair Service Warranty ServiceParts Centrals FastenersApplication Chart Power load and power fastener application information106763 106763 Limited Warranty Agreement A. only