Remington 500V operating instructions Safety Precautions, Handling the Tool

Page 4

Safety Precautions

WARNING

POWDER

ACTUATED !

TOOLS

IN USE

4.ALWAYS clear the work area on all sides and post appropriate warning signs on job sites.

G 018

5.ALWAYS make sure the work area is clean from loose material and debris.

HANDLING THE TOOL

G018

1.NEVER place your hand over the muzzle. Accidental discharge can cause serious injury.

G018

2.NEVER place your finger on the trigger until the tool’s muzzle is against the work surface.

106763

4

Image 4

Contents Model Index Before Using Safety Precautions Handling the ToolPowd Load Powder Loads Know Your Fastening Base Material ? ?Never make fastenings in spalled or cracked areas Operating the Tool Power Loads and Fasteners Never use power loads in firearms Head Shank Plastic Flute WHY a Power Fastener Holds Concrete Why a Power Fastener HoldsWHY a Power Fastener Holds Steel Power Loads and Power Indicator Setting Overdriven Power Fasteners and PistonFastening Into Concrete Fastening Into SteelOperation Water Parts List 500VCleaning and Maintenance Tool Disassembly Removing Barrel AssemblyRemoving Rear PAD and Power Indicator Assembly Removing Handle PAD AssemblyRemoving Rocker ARM Assembly Removing Trigger and Pawl Assembly Removing Firing PINTool Assembly Removing Baffle AssemblyRemoving Outer Liner Assembly from Housing Inserting Outer Liner AssemblyReplacing Trigger and Pawl Assembly Inserting Baffle AssemblyReplacing Advance BAR Replacing Rocker ARM Assembly Replacing Firing PINAttaching Handle PAD Assembly Attaching Rear PAD AssemblyAssembling Barrel Assembly Replacing Key Stop Troubleshooting Guide Problem Possible Cause RemedyReplacement Parts And Accessories Technical ServiceRepair Service Warranty ServiceParts Centrals FastenersApplication Chart Power load and power fastener application information106763 106763 Limited Warranty Agreement A. only