Sanyo CVW-EXA224, CVW-EXA124 Installing Patch Ends, CVW-EXA284/224, CVW-EXA184/124

Page 13

3.8Installing Patch Ends

①Gasket

② M8 Bolts

③ Side Cover

④ Suction Lamp Cover Joint

CVW-EXA284/224

1.Apply gasket to case body (per previous instructions).

2.If present, remove protective film from inside wall of Patch End.

3.Place Patch End to line up with bolt holes.

4.From inside unit ratchet in M8 & optional M5 bolt into Patch End until secure.

5.Apply Silicone sealant between inside of Patch End and lower frame (see drawing to the left for details).

6.Attach side cover (item 3 in above drawing)

⑤M5 Bolts

CVW-EXA184/124

Apply silicone sealant inside after installing the patch end.

13

Image 13

Contents 80 7/8, L 96 3/8 / H 80 7/8, L 144 5/8 MULTI-DECK Fresh Produce CasesActivity Safety Precautions Table of Contents Care and Cleaning Guidelines CVW-EXA284 CVW-EXA224 SpecificationsCVW-EXA184 CVW-EXA124 External Dimensions Footprint DimensionsCVW-EXA184 / CVW-EXA124 Unloading Instructions & Precautions Unloading and Carpentry ProceduresNSF Certification LocationCase Leveling Aligning Cases Perimeter gasket is required by NSF Joining InstructionsConnecting cases CVW-EXA284/224 Installing Patch EndsCVW-EXA184/124 Installing Kickplate Installing Handrail and Bumper Piping Plumbing, Refrigeration Refrigeration, Plumbing & Electrical ProceduresWiring Electrical Guidelines & PrecautionsWiring Color Code Electrical DataWiring Diagram Load Limits OperationMagnet Installing FDA/NSF ThermometerExterior Panels Daily Cleaning Care and Cleaning GuidelinesMirrors, Fluorescent Lamps, Drain Trap Monthly Cleaning Honeycomb Assemblies at least every 3 months Replacing Fan Motors and Blades ServiceTo replace the fan motors For models with Standard-type AC Fan Motors For models with high-efficiency-type DC fan motors To replace electronic ballasts Replacing Electronic BallastsLamp Cover END CAP Replacing Fluorescent LampsSporlan Expansion Valve DanfossPage Sanyo E & E Corporation