TOP Installation, Removal, Retaining clip

TOP INSTALLATION

Tools Required:

Screwdriver, Crosstip

Roll-awaytop removal

•Disconnect power from unit.

•Remove pull out work surface. (See drawer and work surface installation and removal.)

•Remove enough drawers to reach the top back inside of the unit. (See Drawer and Work surface installation and removal.)

•Remove lock retaining clip. Pull lock out to remove.

•Remove (4) screws holding top in place.

•Lift top off of unit enough to reach the wiring harness.

•Disconnect wiring harness from unit.

•Remove top from unit.

Press to

release

AND REMOVAL

Roll-away top installation

•Connect wiring harness to top. Position top on unit. Attach using (4) screws.

•Position lock in unit. Install retaining clip to hold lock in place.

•Make sure the back of the lock rod is inserted into the lock rod holder in the back of the unit.

•Push the lock rod toward the back of unit the and line up with lock. Insert the lock rod into the back of the lock.

•Test lock operation.

•Reinstall drawers.

•Reinstall work surface.

•Reconnect power to the unit.

Lock

DRAWER AND WORK SURFACE

INSTALLATION AND REMOVAL

Note: For pull out work surface without task light, follow drawer removal instructions.

DRAWER

•Empty the drawer.

•Fully extend the drawer.

Release

Lever Style - Lift or lower (depending on the slide) the release lever

on both sides, (this allows the slides to ride

over the stops.) Pull out to remove.

Tab Style - Depress the release tabs on both

sides, (this allows the slides to ride over the

stops.) Pull out to remove.

•To reinstall, carefully align the slides and push the drawer into the unit until the drawer stops.

•Unplug work surface cord from back of roll-away.

•Remove and save back retaining clip.

•Disconnect chain inside back of roll- away. (Move chain toward large round part of slot. Pull out to remove.)

•Remove the work surface. (See drawer removal instructions.)

Retaining

Chain

Installation

• To reinstall, carefully align the slides
and push the work surface into the unit
until the work surface stops.
• Depress release tabs in back corners
of the extendable		work	surface.
• Push the work surface into the unit to
the fully	retracted position.
• Extend work surface far enough to
gain access to		connections		in back.
• Connect	chain	inside	back	of roll

retaining clip

Lock rod		Remove
holder
	Lock rod	screws

PULL OUT WORK SURFACE WITH

TASK LIGHT

Removal

•Disconnect the power from the unit.

•Remove enough drawers to gain access to connections in the back of the roll-away behind the work surface.

away. (insert chain into the large
round part of the slot. Slide chain to
small end	of slot.)
• insert retaining clip to hold chain in
place.
• Plug work surface cord into back of
roll-away.
• Reconnect	power to the unit. (See:
Connecting	power.)
• Check work surface and task lighting
for proper	operation.
• Reinstall	drawers.