TOP Installation and Removal

ACTUATORROD BRACKET

INSTALLATION AND REMOVAL

Removal

LOCK BAR INSTALLATION AND

REMOVAL

Removal

ROLL-AWAYS, CHESTS WITHOUT TASK LIGHT

•Disconnect power from unit.

•For roll-aways, remove work surface.

(See drawer and work surface installation and removal.

•Remove enough drawers to reach the top back inside of the unit. (See Drawer and Work surface installation and removal.)

•Remove top from unit. (See top installation and removal for your unit.)

•Pull actuator rod bracket forward. Lift out to remove.

Installation

•insert actuator rod bracket into hole in back corner of unit. Ensure actuator rod bracket snaps into place. Note: The flexible tab should be in front.

•Reinstall top in unit.

•insert back of actuator rod into

actuator rod holder in top back of unit.

•Push actuator rod toward back of unit

and line up with lock. Insert actuator rod into back of lock.

•Test lock operation.

•Reinstall drawers.

•Reconnect power to the unit.

•Disconnect power from the unit.

•For roll-aways, remove work surface.

(See drawer and work surface installation and removal.

•Remove all drawers.

•Remove actuator rod and actuator channel. (See actuator rod and actuator channel installation and removal.)

•Remove top from unit.

•See top removal for your unit.

•Lift lock bar out through hole in top of unit.

Removal

•Insert lock bar through hole in top of unit.

•Slide lock bar down through lock bar guide.

•Reinstall top on unit.

•Reinstall actuator channel and actuator rod.

•Test lock operation.

•Reinstall drawers.

•Reconnect power to the unit.

Tools Required:

Screwdriver, Crosstip

Removal

•Disconnect power from unit.

•For roll-aways, remove work surface. (See drawer and work surface installation and removal.

•Remove enough drawers to reach the

top back inside of the unit. (See Drawer and Work surface installation

and removal.)

•Remove lock retaining clip. Pull lock out to remove.

•Remove (4) screws holding top in place.

•For roll-aways, lift top off of unit enough to access the wiring harness. Disconnect wiring harness from unit.

•Remove top from unit.

Press to

release

Actuator rod holder

Actuator

Installation

•For roll-aways, connect the wiring harness to unit.

•Position top on unit. Attach using (4) screws.

•Position lock in unit. install retaining clip to hold lock in place.

•Make sure the back of the actuator rod is inserted into the actuator rod holder in the back of the unit.

•Push the actuator rod toward the back of unit the and line up with lock. Insert the actuator rod into the back of the lock.

•Test lock operation.

•Reinstall drawers.

•Reinstall work surface.

•Reconnect power to the unit.

Lock

retaining clip

• JL;

Remove

rodscrews