DRAWER AND WORK SURFACE REPLACEMENT
DRAWER FRONT INSTALLATION AND REMOVAL
Tools Required:
Drill
5/32" Drill bit Rivet gun Crosstip screwdriver
Removal
•Remove drawer or work surface from unit. (See Drawer and Work surface installation and removal.)
•Carefully drill out rivets holding slides to drawer.
•Rotate front of slide down and out.
•Pull slide forward to remove.
Drawers only
•Remove striker. (See striker replacement.)
•Remove drawer front. (See drawer front replacement.)
Right side
Siide
Striker
\
Left side
Slideo
Installation
•Install slides on new drawer or work surface. (install back hangers first.)
•Install rivets to hold slides in place. Drawers only
•Install striker. (See striker replacement.)
•Install drawer front. (See drawer front replacement.)
Drawers and work surface
•Install drawer or work surface in unit. See drawer and work surface installation and removal.
Hanger
pointed up
Drawer
front
Tools Required:
Crosstip screwdriver
Removal
•Remove retaining screw(s).
•Slide drawer front assembly as indicated to unhook mounting tabs.
•Pull out to remove.
Installation
•Position drawer front on drawer assembly.
•insert mounting tabs into notches on drawer.
•Slide drawer front over to attach.
•install retaining screw(s) to hold drawer front in place.
Mounting tab
Notch
Retaining screws
Bottom drawer only
Drawers (4)inches deep or more only
d-
J ,
Rivet
Drawer
3 | 4 |