Chest TOP Installation and Removal

(With task light)

DRAWER AND WORK SURFACE

INSTALLATION AND REMOVAL

• Unplug work surface cord from back of

roll-away.

Tools Required:

3/8" Wrench

Chest Top Removal

•Disconnect power from unit.

•Remove enough drawers to reach the top back inside of the unit. (See Drawer installation and removal.)

•Push actuator rod to back of unit to disconnect from back of lock. Move actuator rod for access.

•Remove (4) screws holding top in place.

•Lift top off of unit enough to reach the wiring harness.

•Disconnect wiring harness from unit.

•Remove top from unit.

Press to

release

Chest Top Installation

•Connect wiring harness to top.

•Position top on unit.

•Attach using (4) screws.

•Make sure the back of the actuator rod is inserted into the actuator rod holder in the back of the unit.

•Push actuator rod toward back of unit and line up with lock. Insert the actuator rod into the back of the lock.

•Test lock operation.

•Reinstall drawers.

•Reconnect power to the unit.

Top

Note: For pull out work surface without task light, follow drawer removal instructions.

DRAWER

•Empty the drawer.

•Fully extend the drawer.

Release

Lever Style - Lift or lower (depending on the slide) the release lever

on both sides, (this allows the slides to ride

over the stops.) Pull out to remove.

Tab Style - Depress the release tabs on both

sides, (this allows the slides to ride over the

stops.) Pull out to remove.

•To reinstall, carefully align the slides and push the drawer into the unit until the drawer stops.

• Remove and save back retaining clip.

• Disconnect chain inside back of roll-

away. (Move chain toward large round

part of slot. Pull out to remove.)

• Remove the work surface. (See

drawer removal instructions.)

Retaining

Chain

Installation

• To reinstall, carefully align the slides
and push the work surface into the unit
until the work surface stops.
• Depress release tabs in back corners
of the extendable	work	surface.
• Push the work surface		into the unit to

Actuator rod holder

Disconnect actuator rod

Remove screws

PULL OUT WORK SURFACE WITH

TASK LIGHT

Removal

•Disconnect the power from the unit.

•Remove enough drawers to gain access to connections in the back of the roll-away behind the work surface.

the fully retracted		position.
• Extend work surface far enough to
gain access to connections			in back.
• Connect chain inside back of roll
away. (Insert chain into the large
round part of the slot. Slide chain to
small end	of slot.)
• Insert retaining clip to hold chain in
place.
• Plug work surface cord into back of
roll-away.
• Reconnect	power	to the unit. (See:
Connecting	power.)
• Check work surface and task lighting
for proper	operation.
• Reinstall	drawers.