Installation and Removal

DRAWER AND WORK SURFACE

Note: For pull out work surface without task light, follow drawer removal instructions.

•Empty the drawer.

•Fully extend the drawer.

Release

Lever Style - Lift or lower (depending on the slide) the release lever

on both sides, (this allows the slides to ride

over the stops.) Pull out to remove.

Tab Style - Depress the release tabs on both

sides, (this allows the slides to ride over the

stops.) Pull out to remove.

•To reinstall, carefully align the slides and push the drawer into the unit until the drawer stops.

•Disconnect the power from the unit.

•Remove enough drawers to gain access to connections in the back of

the roll-away behind the work

surface.(Follow drawer removal instructions.)

•Unplug work surface cord from back of roll-away.

•Remove and save back retaining clip.

•Disconnect chain inside back of roll- away. (Move chain toward large round part of slot. Pull out to remove.)

•Remove the work surface. (See drawer removal instructions.)

Retaining clip

Chain

Installation

•To reinstall, carefully align the slides and push the work surface into the unit until the work surface stops.

•Depress release tabs in back corners of the extendable work surface.

•Push the work surface into the unit to the fully retracted position.

•Extend work surface far enough to gain access to connections in back.

•Connect chain inside back of roll away. (Insert chain into the large round part of the slot. Slide chain to small end of slot.)

•Insert retaining clip to hold chain in place.

•Plug work surface cord into back of roll-away.

•Reconnect power to the unit. (See: Connecting power.)

•Check work surface and task lighting for proper operation.

•Reinstall drawers.