Lock Replacement

ICRAFTSMAN°I

DRAWER AND WORK SURFACE

INSTALLATION AND REMOVAL

Note: For pull out work surface without task light, follow drawer removal instructions.

DRAWER

•Empty the drawer.

•Fully extend the drawer.

•Unplug work surface cord from back of roll-away.

•Remove and save back retaining clip.

•Disconnect chain inside back of roll- away. (Move chain toward large round part of slot. Pull out to remove.)

•Remove the work surface. (See drawer removal instructions.)

Removal

•Disconnect power from unit.

•For roll-aways, remove work surface.

(See drawer and work surface installation and removal

•Remove enough drawers to reach the lock retaining clip behind the lock.

•Remove lock retaining clip. Pull lock out to remove.

Installation

•Position lock in unit. Install retaining clip to hold lock in place.

•Make sure the back of the actuator rod is inserted into the actuator rod holder in the back of the unit.

•Push actuator rod toward back of unit

and line up with lock. Insert the actuator rod into the back of the lock.

•Test lock operation.

•Reinstall drawers.

Lock

Actuator rod holder

Lock

retaining clip

Rekeying MASTERLOCK ® ONE- KEY TM lock

The MASTERLOCK ® ONE_KEyTM learning lock system allows the chest and cabinet to be keyed alike. The lock can also be keyed to most house keys.

•Insert current key and turn lock to the right until access notch appears at top of lock.

•Depress and hold catch through access notch using re-keying tool provided.

•Remove key.

•Insert new key.

•Release catch

•Turn lock to center position.

•Remove key

Note: Catch must be depressed to insert or remove key in right hand position. Catch may be released between keys.

Access

keying

Release

Lever Style - Lift or lower (depending on the slide) the release lever

on both sides, (this allows the slides to ride

over the stops.) Pull out to remove.

Tab Style - Depress the release tabs on both

sides, (this allows the slides to ride over the

stops.) Pull out to remove.

•To reinstall, carefully align the slides and push the drawer into the unit until the drawer stops.

PULL OUT WORK SURFACE WITH

TASK LIGHT

Removal

•Disconnect the power from the unit.

•Remove enough drawers to gain access to connections in the back of the roll-away behind the work surface.

Retaining

Chain

Installation

•To reinstall, carefully align the slides and push the work surface into the unit until the work surface stops.

•Depress release tabs in back corners of the extendable work surface.

•Push the work surface into the unit to the fully retracted position.

•Extend work surface far enough to gain access to connections in back.

•Connect chain inside back of roll away. (Insert chain into the large round part of the slot. Slide chain to small end of slot.)

•Insert retaining clip to hold chain in place.

•Plug work surface cord into back of roll-away.

•Reconnect power to the unit. (See: Connecting power.)

•Check work surface and task lighting for proper operation.

•Reinstall drawers.

Sears, Roebuck and Co., Hoffman Estates, IL 60179, USA

F1623