CAUTION :
DO NOT attempt to operate the roller until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood.
This section is intended to assist the operator with the initial
STARTING THE ENGINE
The engine can be started by motor (electric) or manually (recoil). Refer to Figures 3 and 4 for the location of controls and components.
CAUTION :
Make sure to follow all safety rules referenced in thesafetysectionofthismanualbeforeoperating roller. Keep work area clear of debris and other objects that could cause damage to the roller or bodily injury.
MRH-800DS— INITIAL STARTUP
5.Insert the starter key into the key switch and turn it to the RUN position (Figure 14). The buzzer should sound at this time.
Figure 14. Starter Key (Run Position)
6Turn the starter key further to the right to the START position to start the engine. Buzzer stops sounding when the engine speed increases. With safety switch equipped, motor runs only when the travel lever is in the neutral position.
CAUTION :
When the engine is running, NEVER turn the starter key to the START position
Electric Start
1.On the control handle:
A.Move the throttle lever to the RUN position.
B.Move the travel lever to the NEUTRAL position.
C.Move the vibration lever to the OFF position.
4.Open the fuel cock by turning it clockwise to the down position (Figure 13).
Fuel Cock (Open Position)
Figure 13. Open Fuel Cock
Figure 15. Starter Key (Start Position)
7.If the engine fails to start, DO NOT continue to rotate the starter key for more than 5 seconds. Return the key to the RUN position and wait 20 to 30 seconds before starting again.
8.After starting the engine, continue to warm up the engine for about 3 to 10 seconds especially in cold weather.
9.If the buzzer does not stop sounding after the engine has started, shutdown engine immediately and check engine oil level. The buzzer functions as engine oil level warning also.
PAGE 24 —