Prestige 100 and 100IH ISDN Router and Router/Hub
Action Not Matched
Select the action for a packet not matching the rule.
Check Next
Rule
Forward
Drop
Once you have completed filling in Menu 21.1.2 - generic Filter Rule, press [Enter] at the message [Press Enter to Confirm] to save your configuration, or press [Esc] to cancel. This data will now be displayed on Menu 21.1 - Filter Rules Summary.
8.4Applying a Filter and Factory Defaults
This section shows you where to apply the filter(s) after you design it (them). Two sets of factory default filter rules have been configured in Menu 21 to prevent NetBIOS traffic from triggering calls (see Figure
8.4.1 Ethernet traffic
You seldom need to filter Ethernet traffic; however, the filter sets may be useful to block certain packets, reduce traffic and prevent security breaches. Go to Menu 3.1 (shown below) and enter the number(s) of the filter set(s) that you want to apply as appropriate. You can choose up to four filter sets (from twelve) by entering their numbers separated by commas, e.g., 3, 4, 6, 11.
Menu 3.1 - General Ethernet Setup
Ethernet Interface= 10BaseT
Input Filter Sets: protocol filters= device filters= Output Filter Sets: protocol filters= device filters=
Figure 8-7 Filtering Ethernet traffic
Filter Configuration |