Prestige 100 and 100IH ISDN Router and Router/Hub
Chapter 4
Remote Node Configuration
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up Internet access, you are actually configuring one of the remote nodes. Once a remote node is configured correctly, traffic to the remote network will trigger your Prestige to make a call automatically, i.e., Dial On Demand.
In this chapter, we will discuss the parameters that are protocol independent. The protocol- dependent configuration (TCP/IP) will be covered in Chapter 5.
4.1Remote Node Setup
This section describes the
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1. From the Main Menu, select menu option 1. Remote Node Setup
Step 2. When Menu 11 appears, as shown below, enter the number of the remote node that you wish to configure.
Remote Node Configuration |