Prestige 100 and 100IH ISDN Router and Router/Hub
Addition and subtraction are based on the value set in the BOD Calculation field. If this field is set to Transmit or Receive, then traffic in either direction will be included to determine if a link should be added or dropped. Transmit will only use outgoing traffic to make this determination and Receive will only use incoming traffic to make this determination.
If, after making the call to bring up a second channel, the second channel does not succeed in joining the Multilink Protocol bundle (because the remote device does not recognize the second call as coming from the same device), the Prestige will hang up the second call and continue with the first channel alone.
The BOD configuration is through Menu 11.2 - Remote Node PPP Options.
4.1.5 Editing PPP Options
To edit the remote node PPP Options, move the cursor to the Edit PPP Options field in Menu
11.1- Remote Node Profile, and use the space bar to select Yes. Press Enter to open Menu 11.2, as shown below.
Menu 11.2 - Remote Node PPP Options
Encapsulation= Standard PPP
Compression= No
Multiple Link Options:
BOD Calculation= Transmit or Receive
Base Trans Rate(Kbps)= 64
Max Trans Rate(Kbps)= 64
Target Utility(Kbps)=
Add Persist(sec)= 5
Subtract Persist(sec)= 5
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.
Figure 4-3 Menu 11.2 - Remote Node PPP Options
The following table describes the Remote Node PPP Options Menu, and contains instructions on how to configure the PPP options fields.
Remote Node Configuration |