Kenmore 625.38376 owner manual Clean Feature Clean Feature Minutes 97% Feature, 12 / 24 Hour Clock

OPTIONAL SETTINGS:

•SALT EFFICIENCY

•CLEAN FEATURE

•CLEAN FEATURE MINUTES

•97% FEATURE

•12 / 24 HOUR CLOCK

•GALLONS / LITERS

•MAXIMUM DAYS BETWEEN REGENERATIONS

1.To set any of the following options, press and hold SELECT1 for 3 seconds until 000 shows in the display Then press once until the SALT EFFICIENCY display shows. Use the UP or DOWN buttons to change the ON / OFF displays.

Salt Efficiency. When this feature is ON, the unit will operate at salt efficiencies of 4000 grains of hardness per pound of salt or higher, which will reduce the sof- teners salt usage. (May recharge more often using smaller salt dosage and less water). When installing

this unit in the State of California, this setting MUST be ON.

California Efficiency Requirement

Your Kenmore Water Softener has a "High Efficiency" feature with an "ON" or "OFF" setting. This softener set- ting is shipped in the "OFF" position, which utilizes the maximum rated capacity while most often achieving maximum salt efficiencies. When installing this unit in the State of California, you MUST turn this setting to the "ON" position which may initiate more frequent recharges, however it will operate at 4000 grains per pound of salt or higher.

2.Press SELECT1 again to show the CLEAN display. Clean. This feature is beneficial on water supplies con-

silt, dirt, etc.). When set to ON, a backwash and fast rinse cycle will occur first, preceding the normal regen- taining iron and/or high amounts of sediments (sand, eration sequence (see pages 26 - 28). This provides

extra cleaning of the resin bed before it is regenerated with the salt brine. To conserve water, if your water supply does not contain iron or sediments, be sure this feature is set to OFF. The default is ON.

3.Press SELECT1 again until the CLEAN TIME display showsClean feature minutes: If you are using this feature, the length of the extra backwash cycle automatically is set to 3 minutes. However, you can adjust this time

from 1 to 15 minutes in length. To change this cycle time, use the UP button to increase, the time, or the DOWN button to shorten the time. If no change is desired, continue to next step.

8 u_- _-

I_:{R n - -

_ ___ _

I
I_:__	nFF
8	I__lF I-
i
I _	CLEAN
- j-	-

i CLEANI

T/ME

i

- J- -

Default Minutes

,U 17

_ ___ _

FIG. 36

,U lq

CLEAN

_ ___ _

FIG. 37

8

CLEAN TIME

7

_ ___ _

Example:

Time Set to 7 Minutes

FIG. 38

Questions? Call The Kenmore Water Line 1-800-426-9345

23