Woodstock M1103, M1102 owner manual Headstock, Aligning headstock with a Typical drill press base

Page 16

M1102/M1103 16-Speed Drill Press

Headstock

SET UP

The headstock must be mounted on the column/base assembly before the drill press can be operated. Moving and installing the headstock is a two-person job.

The headstock is very heavy. In the next step, you MUST have assistance when moving, lifting or mounting the headstock on the column and base assembly.

To install the headstock, do these steps:

1.Loosen the two set screws on the right side of the headstock enough so they are flush with the inside pocket of the headstock.

NOTICE

When doing the next step, DO NOT force the head- stock onto the column! If you do, you could damage the headstock and the column.

2.With the help of an assistant, lift the headstock assembly above the column, and gently slide it down the column as far as it will go.

Note: An alternate method is to lay the headstock on the packaging styrofoam and slide the column into the headstock, tilt the assembly up, and posi- tion the drill press on its base in the upright posi- tion.

3.Place a ruler or tape measure on the base and suspend a plum bob from the center of the headstock spindle so it is over the tape/ruler as shown in Figure 9.

4.Center the headstock directly over the base as indicated by the plum bob and ruler.

5.Tighten the two headstock setscrews to the column, as shown in Figure 10.

Figure 9. Aligning headstock with a

typical drill press base.

Figure 10. Securing headstock to column.

-14-

Image 16

Contents Speed Drill Press Page Contents Service Woodstock Technical Support IntroductionAbout Your New 16-Speed Drill Press M1102 Specifications M1103 SpecificationsIdentification Cast Iron Base with T-Nut Slots Allows for maxiSafety Instructions for Machinery SafetyBefore Operating this Machine Always Lock Mobile Bases if Used Before Operating Machinery Safety for Drill Presses Electrical 110V OperationExtension Cords GroundingUnpacking SET UPInventory Machine Placement Cleaning MachineTo install the table support Column and BaseTable Support To secure the column to the base, do these stepsSliding table support and rack Over the column Headstock Aligning headstock with a Typical drill press baseChuck Guard To install the chuck guard, do these stepsDrill Chuck & Arbor Seating arbor into chuck To install the table, do these steps To install the downfeed handles, do these stepsDownfeed Handles & Belt Cover Knob Test Run Work LightTo test run the drill press Mounting To mount the Model M1102 drill press to a tableInstalling & Removing Drill Bits To install a drill bit, do these stepsOperations GeneralChanging Spindle RPM To change spindle RPM, do these stepsAdjusting Table Tilt Depth StopTo set the depth stop, do these steps To tilt the table, do these stepsOperations Operations Arbor Removal To remove the drill chuck and arbor, do these stepsMaintenance BeltsTable and Base LubricationService TroubleshootingM1102/M1103 16-Speed Drill Press Drill Press Operations Feed Shaft Spring Tension Electrical Components Capacitor110V Wiring Diagram M1102/M1103Wiring Diagram PartsService Notes M1102/M1103 Parts Diagram M1102/M1103 Parts List PART# DescriptionWiringharness Label Placement and Parts REF PART# DescriptionParts Notes Warranty Warranty Registration CommentsBOX BELLINGHAM, WA