Woodstock M1103, M1102 owner manual Seating arbor into chuck

Page 18

M1102/M1103 16-Speed Drill Press

4.Place the drill chuck face down on a workbench. The arbor has a short taper and a long taper. Place the short taper into the socket in the back of the drill chuck and tap it with a rubber or wooden mallet, as shown in Figure 13. If the chuck fails to remain secure on the arbor, repeat Steps 1 & 2.

5.Raise the chuck guard.

6.Slide the arbor into the spindle socket while slowly rotating the drill chuck. The socket has a rectangular pocket where the tang (or flat portion of the arbor shown in Figure 13) fits into.

7.Using only a rubber or wooden mallet, tap the chuck and arbor assembly into the quill as shown in Figure 14. DO NOT use a steel hammer.

DO NOT use a steel hammer on the drill chuck to seat the arbor into the spindle. You will damage the chuck and/or spindle, which may make them unusable or unsafe.

SET UP

Figure 13. Seating arbor into chuck.

Figure 14. Seating arbor and chuck into

spindle.

-16-

Image 18

Contents Speed Drill Press Page Contents Service Introduction Woodstock Technical SupportAbout Your New 16-Speed Drill Press M1102 Specifications M1103 SpecificationsIdentification Cast Iron Base with T-Nut Slots Allows for maxiSafety Safety Instructions for MachineryBefore Operating this Machine Always Lock Mobile Bases if Used Before Operating Machinery Safety for Drill Presses Extension Cords Electrical110V Operation GroundingSET UP UnpackingInventory Machine Placement Cleaning MachineTable Support To install the table supportColumn and Base To secure the column to the base, do these stepsSliding table support and rack Over the column Headstock Aligning headstock with a Typical drill press baseTo install the chuck guard, do these steps Chuck GuardDrill Chuck & Arbor Seating arbor into chuck To install the downfeed handles, do these steps To install the table, do these stepsDownfeed Handles & Belt Cover Knob Work Light Test RunTo test run the drill press Mounting To mount the Model M1102 drill press to a tableOperations Installing & Removing Drill BitsTo install a drill bit, do these steps GeneralChanging Spindle RPM To change spindle RPM, do these stepsTo set the depth stop, do these steps Adjusting Table TiltDepth Stop To tilt the table, do these stepsOperations Operations Arbor Removal To remove the drill chuck and arbor, do these stepsTable and Base MaintenanceBelts LubricationService TroubleshootingM1102/M1103 16-Speed Drill Press Drill Press Operations Feed Shaft Spring Tension Electrical Components Capacitor110V Wiring Diagram M1102/M1103Wiring Diagram PartsService Notes M1102/M1103 Parts Diagram M1102/M1103 Parts List PART# DescriptionWiringharness Label Placement and Parts REF PART# DescriptionParts Notes Warranty Warranty Registration CommentsBOX BELLINGHAM, WA