Woodstock M1102, M1103 owner manual Label Placement and Parts, REF PART# Description

Page 39

M1102/M1103 16-Speed Drill Press

Label Placement and Parts

Safety labels warn about machine hazards and how to prevent machine damage or injury. The owner of this machine MUST maintain the original location and readability of all labels on this machine. If any label is removed or becomes unreadable, REPLACE that label before allowing the machine to enter service again. Contact Woodstock International, Inc. at (360) 734-3482 or www. shopfoxtools.com to order new labels.

91

94

92

93

95

96

97

REF PART�# DESCRIPTION

191	XLABEL01H	SAFETY�GLASSES�LABEL
192	XLABEL03	CLOSE�COVER�LABEL
193	XM1102193	MACHINE�DATA�LABEL�(M1102)
193	XM1103193	MACHINE�DATA�LABEL�(M1103)
194	XM1102194	SHOP�FOX�LOGO�PLATE
195	XLABEL04S	ELECTRICAL�LABEL
196	XM1102196	MOTOR�DATA�LABEL
197	XM1102197	BELT�SPEEDS�LABEL

PARTS

-37-

Image 39

Contents Speed Drill Press Page Contents Service Introduction Woodstock Technical SupportAbout Your New 16-Speed Drill Press M1103 Specifications M1102 SpecificationsCast Iron Base with T-Nut Slots Allows for maxi IdentificationSafety Safety Instructions for MachineryBefore Operating this Machine Always Lock Mobile Bases if Used Before Operating Machinery Safety for Drill Presses Grounding Electrical110V Operation Extension CordsSET UP UnpackingInventory Cleaning Machine Machine PlacementTo secure the column to the base, do these steps To install the table supportColumn and Base Table SupportSliding table support and rack Over the column Aligning headstock with a Typical drill press base HeadstockTo install the chuck guard, do these steps Chuck GuardDrill Chuck & Arbor Seating arbor into chuck To install the downfeed handles, do these steps To install the table, do these stepsDownfeed Handles & Belt Cover Knob Work Light Test RunTo test run the drill press To mount the Model M1102 drill press to a table MountingGeneral Installing & Removing Drill BitsTo install a drill bit, do these steps OperationsTo change spindle RPM, do these steps Changing Spindle RPMTo tilt the table, do these steps Adjusting Table TiltDepth Stop To set the depth stop, do these stepsOperations Operations To remove the drill chuck and arbor, do these steps Arbor RemovalLubrication MaintenanceBelts Table and BaseTroubleshooting ServiceM1102/M1103 16-Speed Drill Press Drill Press Operations Feed Shaft Spring Tension Capacitor Electrical ComponentsParts 110V Wiring Diagram M1102/M1103Wiring DiagramService Notes M1102/M1103 Parts Diagram PART# Description M1102/M1103 Parts ListWiringharness REF PART# Description Label Placement and PartsParts Notes Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA