Woodstock M1102, M1103 Downfeed Handles & Belt Cover Knob, To install the table, do these steps

Page 19

M1102/M1103 16-Speed Drill Press

Downfeed Handles & Belt

Cover Knob

The downfeed handles must be installed to properly oper- ate the drill press.

To install the downfeed handles, do these steps:

1.Thread the knobs onto the handles, then thread the handles into the spindle hub, as shown in Figure 15, and tighten.

2.Install the belt cover knob in its place (see Figure 15 for location).

Table

The table must be installed to properly support the workpiece during operation.

To install the table, do these steps:

1.Insert the table shaft into the table support assem- bly.

2.Tighten the small locking lever (Figure 16) to secure the table in the table support assembly.

-17-

Spindle Hub

Belt Cover

Knob

Figure 15. Downfeed handles and belt

cover knob installed.

Figure 16. Table installed.

SET UP

Image 19

Contents Speed Drill Press Page Contents Service Woodstock Technical Support IntroductionAbout Your New 16-Speed Drill Press M1103 Specifications M1102 SpecificationsCast Iron Base with T-Nut Slots Allows for maxi IdentificationSafety Instructions for Machinery SafetyBefore Operating this Machine Always Lock Mobile Bases if Used Before Operating Machinery Safety for Drill Presses Grounding Electrical110V Operation Extension CordsUnpacking SET UPInventory Cleaning Machine Machine PlacementTo secure the column to the base, do these steps To install the table supportColumn and Base Table SupportSliding table support and rack Over the column Aligning headstock with a Typical drill press base HeadstockChuck Guard To install the chuck guard, do these stepsDrill Chuck & Arbor Seating arbor into chuck To install the table, do these steps To install the downfeed handles, do these stepsDownfeed Handles & Belt Cover Knob Test Run Work LightTo test run the drill press To mount the Model M1102 drill press to a table MountingGeneral Installing & Removing Drill BitsTo install a drill bit, do these steps OperationsTo change spindle RPM, do these steps Changing Spindle RPMTo tilt the table, do these steps Adjusting Table TiltDepth Stop To set the depth stop, do these stepsOperations Operations To remove the drill chuck and arbor, do these steps Arbor RemovalLubrication MaintenanceBelts Table and BaseTroubleshooting ServiceM1102/M1103 16-Speed Drill Press Drill Press Operations Feed Shaft Spring Tension Capacitor Electrical ComponentsParts 110V Wiring Diagram M1102/M1103Wiring DiagramService Notes M1102/M1103 Parts Diagram PART# Description M1102/M1103 Parts ListWiringharness REF PART# Description Label Placement and PartsParts Notes Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA