Woodstock M1102, M1103 Arbor Removal, To remove the drill chuck and arbor, do these steps

Page 27

M1102/M1103 16-Speed Drill Press

Arbor Removal

The arbor can be removed to install another drill chuck in the spindle. A drift key is included to help remove the arbor from the spindle. Usually, once the chuck and arbor have been properly mounted together, they are consid- ered semi-permanent connections. (If you would like to install a different chuck, we recommend getting a new arbor for that chuck.)

To remove the drill chuck and arbor, do these steps:

1.DISCONNECT THE DRILL PRESS FROM POWER!

2.Rotate the downfeed handles until the drift-key slot is exposed in the side of the quill. For now, keep the downfeed handles in this position.

3.Move the table up until it is 1⁄4" below the bottom of the chuck, and place a towel or cloth under the chuck.

4.Rotate the spindle until the inner drift-key slot is aligned with the outer slot, as shown in Figure 24. You will see through the spindle when the slot is properly aligned.

5.Insert the drift key into the drift-key slot.

6.Tap the drift key with a rubber or wooden mallet, as shown in Figure 25, until the chuck releases and catch the chuck with your hand.

7.Remove the drift key and carefully retract the quill into the headstock.

-25-

Both

Slots

Aligned

Figure 24. Inner and outer drift-key slots

aligned.

Figure 25. Using drift key to remove arbor.

OPERATIONS

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Speed Drill Press Page Contents Service Introduction Woodstock Technical SupportAbout Your New 16-Speed Drill Press M1103 Specifications M1102 SpecificationsCast Iron Base with T-Nut Slots Allows for maxi IdentificationSafety Safety Instructions for MachineryBefore Operating this Machine Always Lock Mobile Bases if Used Before Operating Machinery Safety for Drill Presses Grounding Electrical110V Operation Extension CordsSET UP UnpackingInventory Cleaning Machine Machine PlacementTo secure the column to the base, do these steps To install the table supportColumn and Base Table SupportSliding table support and rack Over the column Aligning headstock with a Typical drill press base HeadstockTo install the chuck guard, do these steps Chuck GuardDrill Chuck & Arbor Seating arbor into chuck To install the downfeed handles, do these steps To install the table, do these stepsDownfeed Handles & Belt Cover Knob Work Light Test RunTo test run the drill press To mount the Model M1102 drill press to a table MountingGeneral Installing & Removing Drill BitsTo install a drill bit, do these steps OperationsTo change spindle RPM, do these steps Changing Spindle RPMTo tilt the table, do these steps Adjusting Table TiltDepth Stop To set the depth stop, do these stepsOperations Operations To remove the drill chuck and arbor, do these steps Arbor RemovalLubrication MaintenanceBelts Table and BaseTroubleshooting ServiceM1102/M1103 16-Speed Drill Press Drill Press Operations Feed Shaft Spring Tension Capacitor Electrical ComponentsParts 110V Wiring Diagram M1102/M1103Wiring DiagramService Notes M1102/M1103 Parts Diagram PART# Description M1102/M1103 Parts ListWiringharness REF PART# Description Label Placement and PartsParts Notes Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA
Top Page Image Contents