Woodstock M1102, M1103 owner manual Contents

Page 3

Contents
INTRODUCTION	3
Woodstock Technical Support	3
About Your New 16-Speed Drill Press	3
Specifications	4
Identification	5
SAFETY	6
Safety Instructions for Machinery	6
Safety for Drill Presses	8
ELECTRICAL	9
110V Operation	9
Extension Cords	9
Grounding	9
SET UP	10
Unpacking	10
Inventory	10
Machine Placement	11
Cleaning Machine	11
Column and Base	12
Table Support	12
Headstock	14
Chuck Guard	15
Drill Chuck & Arbor	15
Downfeed Handles & Belt Cover Knob	17
Table	17
Work Light	18
Test Run	18
Mounting	19
OPERATIONS	20
General	20
Installing/Removing Drill Bits	20
Changing Spindle RPM	21
Depth Stop	22
Adjusting Table Tilt	22
Arbor Removal	25
MAINTENANCE	26
General	26
V-Belts	26
Table and Base	26
Lubrication	26
Continued on next page

INTRODUCTION SAFETY ELECTRICAL

SET UP OPERATIONS MAINTENANCE SERVICE

USE THE QUICK GUIDE PAGE LABELS TO SEARCH OUT INFORMATION FAST!

PARTS

Image 3

Contents Speed Drill Press Page Contents Service Introduction Woodstock Technical SupportAbout Your New 16-Speed Drill Press M1103 Specifications M1102 SpecificationsCast Iron Base with T-Nut Slots Allows for maxi IdentificationSafety Safety Instructions for MachineryBefore Operating this Machine Always Lock Mobile Bases if Used Before Operating Machinery Safety for Drill Presses Grounding Electrical110V Operation Extension CordsSET UP UnpackingInventory Cleaning Machine Machine PlacementTo secure the column to the base, do these steps To install the table supportColumn and Base Table SupportSliding table support and rack Over the column Aligning headstock with a Typical drill press base HeadstockTo install the chuck guard, do these steps Chuck GuardDrill Chuck & Arbor Seating arbor into chuck To install the downfeed handles, do these steps To install the table, do these stepsDownfeed Handles & Belt Cover Knob Work Light Test RunTo test run the drill press To mount the Model M1102 drill press to a table MountingGeneral Installing & Removing Drill BitsTo install a drill bit, do these steps OperationsTo change spindle RPM, do these steps Changing Spindle RPMTo tilt the table, do these steps Adjusting Table TiltDepth Stop To set the depth stop, do these stepsOperations Operations To remove the drill chuck and arbor, do these steps Arbor RemovalLubrication MaintenanceBelts Table and BaseTroubleshooting ServiceM1102/M1103 16-Speed Drill Press Drill Press Operations Feed Shaft Spring Tension Capacitor Electrical ComponentsParts 110V Wiring Diagram M1102/M1103Wiring DiagramService Notes M1102/M1103 Parts Diagram PART# Description M1102/M1103 Parts ListWiringharness REF PART# Description Label Placement and PartsParts Notes Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA