Finish Mounting
❒Align the cover plate, gasket, and the mounting bracket hole. Secure with M5 x 0.8 x 40 mm mounting screw supplied.
❒Push the rubber plug firmly into place.
❒If not installed on a weatherproof box, caulk between the cover plate and mounting sur- face with silicone weather sealant.
❒Adjust the lamp holders by loosening the thumb screws but do not rotate the lamp hold- ers more than 180° from the factory setting. When screwing in the floodlamps, do not overtighten.
To avoid water damage and electrical shock, keep lamp holders aimed below horizontal.
Rubber Plug
Specifications
Range . . . . . . . . 70 feet (21.0 m); 100 feet (30.5 m) with Range Boost. Varies with surrounding temperature.
Sensing Angle. . . . . Up to 270° (Adjustable)
Fixture Load. . . . . . Up to 300 Watts Maximum Tungsten Incandescent [Up to 150 Watts maximum each lamp holder.]
Sensor Load Capacity. . Up to 1000 Watts (8.3 amps) Maximum Tungsten Incan- descent
Power Requirements. . . 120 VAC, 60 Hz
Operating Modes. . . . TEST,AUTO,andMANUAL OVERRIDE
Time Delay. . . . . . 1, 5, 20 minutes
HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
- - |