INSTALLATION
WINDOW INSTALLATON
6 | Lower window sash |
|
| Level | |
|
| ||||
| Top bar |
|
|
|
|
|
|
|
|
| |
|
|
|
|
| |
|
| Window sill |
| Bottom bar | |||||
|
| 1 1/4” space |
|
|
|
|
| Leveling bracket | |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| |||
|
|
|
| Screw |
|
|
| SIDE VIEW | |
|
|
|
|
|
| ||||
|
|
| Sill edge |
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| 7 | Plastic foam seal |
|
|
|
| Upper window sash | ||
|
|
|
|
| |||||
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
Lower window sash
5/8” wood screws
Window sill | Filler panel |
INSIDE VIEW
5.Keeping a firm grip on air conditioner, carefully center air conditioner in window opening with the bottom bar sitting behind window sill. Be sure cabinet maintains an outward pitch. Air conditioner should slant slightly downward on the outside as shown by half a bubble off on a carpenter’s level. This outward pitch prevents water from entering the room (Fig. 6).
6.Close window until it touches behind air conditioner top bar. Slide filler panels outward until they touch window sash tracks. (Do not release grip on air conditioner until lower window sash is in final position)
(Fig. 7).
7.Secure top of filler panels by driving 5/8” long wood screws through top mounting holes into window sash (Fig. 7).
8.Secure bottom of filler panels by driving 5/8” long screws into window sill through filler panel tabs (Fig. 7).
9.Cut plastic foam seal to width of window and install between upper and lower window sash (Fig. 7).
10.Use sealant to fill any minor openings.
Installation in Minimum Width Window
1.Remove both filler panels from air conditioner cabinet (Fig. 3).
2.Refer to steps 1 through 7 of preceding instructions (Pgs. 4 & 5).
3.Close window until it touches behind air conditioner top bar (Fig. 6).
4.Fasten lower window sash to window frame (use finishing nails, wood screws, or “L” brackets) (Fig. 7).
5.If filler is required on sides of air conditioner, cut plastic foam seal to size and fill both sides.
6.Cut plastic foam seal to width of window and install between upper and lower window sash (Fig. 7).
7.Use sealant to fill any minor openings.
Consult your authorized dealer or importer for alternative installation instructions.
CAUTION
Do not drill a hole in bottom pan. Unit is designed to operate with approximately 1/2” of water in bottom pan.
4