Fedders A7Q08F2B Directing Airflow, Cleaning Air Filter, Occurrence Possible Cause Solutions

Page 7

Directing Airflow

Unit is engineered with adjustable louvers to direct discharge airflow. Louvers are manually adjusted by moving levers in direction of desired airflow (Fig. 8).

Cleaning Air Filter

Clean the filter every two weeks

1.Turn unit OFF.

2.Remove the air filter by grasping the top corners and pulling it up and out of the unit (Fig. 8).

3.Wash in hot soapy water, rinse and shake dry.

4.Replace the filter, with the front of the filter toward you.

5.To dry the filter thoroughly, run your unit for a few minutes. Remember, only a clean filter works properly and delivers top performance.

CAUTION

Failure to keep air filter clean will result in poor air circulation.

DO NOT operate without filter. This can render the unit inoperative.

SERVICE

TROUBLESHOOTING

8

Adjustable louvers

Air filter

Proper use and care of your air conditioner will help ensure longer life of the unit. It is recommended to annually inspect and clean the coils and condensate water passages. Expense of annual inspection is the consumers’ responsibility.

CAUTION

Before cleaning or servicing this unit, it is recommended that the unit be disconnected from any electrical supply outlet.

Troubleshooting Guide

 

Occurrence

Possible Cause

Solutions

 

Air conditioner will not operate

• Wall plug disconnected.

✔ Push plug firmly into wall outlet.

 

 

• House fuse blown or circuit breaker tripped.

✔ Replace fuse with time delay type

 

 

 

or reset circuit breaker.

 

 

• Power control in OFF position.

✔ Turn power control to ON.

 

 

• Unit accidentally turned off by moving the

✔ Wait approximately 3 minutes.

 

 

thermostat to a higher temperature and then

Listen for the compressor to start.

 

 

immediately turned back to a colder position.

 

 

 

• Unit turned off and then on too quickly.

✔ If air conditioner is turned off,

 

 

 

wait 3 minutes before restarting.

 

 

• Thermostat set too low for cooling.

✔ Adjust thermostat to higher setting for cooling.

 

 

 

 

 

Air from unit does not

• Selector in fan position.

✔ Set mode to cool position.

 

feel cold enough

• Thermostat set too warm.

✔ Set thermostat to colder temperature.

 

 

• Room temperature below 70°F.

✔ Cooling may not occur until room

 

 

 

temperature rises above 70°F.

 

 

 

 

 

Air conditioner cooling,

• Outdoor temperature below 70°F.

✔ To defrost the coil, set selector to FAN position.

 

but room is too warm —

 

Then, set thermostat to warmer position.

 

ice forming on cooling coil

• Dirty air filter — air restricted.

✔ Clean filter. See “Cleaning the Air Filter” section.

 

behind decorative front

 

To defrost, set selector to FAN.

 

 

• Thermostat set too cold for nighttime cooling.

✔ To defrost the coil, set selector to FAN position.

 

 

 

 

 

Air conditioner cooling,

• Dirty air filter — air restricted.

✔ Clean air filter. Refer to“Cleaning the air filter”

 

but room too warm —

 

section (above).

 

NO ice forming on cooling coil

• Thermostat set too warm.

✔ Set thermostat to colder setting.

 

behind decorative front

• Fan selector set on LOW.

✔ Set fan speed selector to HIGH

 

 

 

for maximum cooling.

 

 

 

 

 

Noise when unit is cooling

• Air movement sound.

✔ The sound of rushing air is normal. If too loud,

 

 

 

turn selector to lower fan setting.

 

 

• Sound of fan hitting water-moisture

✔ This is normal when humidity is high.

 

 

removal system.

Close doors, windows and registers.

 

 

• Window vibration — poor installation.

✔ Refer to installation instructions —

 

 

 

check with installer.

 

 

 

 

 

Water dripping inside

• Improper installation.

✔ Tilt air conditioner slightly to the outside to

 

when unit is cooling

 

allow water drainage. Refer to installation

 

 

 

instructions — check with installer.

 

 

 

 

 

Water dripping outside

• Unit removing large quantity of moisture

✔ This is normal during excessively humid days.

 

when unit is cooling

from humid room.

 

 

 

 

 

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Garantía EnglishOr email customerservice@fedders.com InstallationImportant Grounding Requirements Unit & Window Size Installation in Normal Width WindowTools Needed Window RequirementsInside View Installation in Minimum Width WindowCheck Filter Light/Reset some models Power ControlSet Temperature/Timer Display Temperature/Timer Hour ControlsTo turn the unit on using the Timer Timer ControlAir Conditioner Remote Control Timer can be set to either turn the unit on or offTroubleshooting Guide Cleaning Air FilterOccurrence Possible Cause Solutions ServiceExceptions How to Obtain Warranty Service or PartsRoom Air Conditioner Warranty WarrantyPrecauciones de Seguridad Adicionales Riesgo de Choque EléctricoRequerimientos Importantes para la Puesta a Tierra InstalacionInstale los paneles de llenado En algunos modelos Herramientas necesariasRequisitos de la ventana Tamaño de la ventana y de la unidadConsultar los pasos 1 a 7 de las instrucciones precedentes Instalación en una ventana de ancho mínimoControl de modo Control de alimentaciónPantalla de configuración de temperatura/reloj Controles de temperatura/hora del relojPRECAUCION´ Control de velocidad del ventiladorControl del reloj Control Remoto de Acondicionador de AireLimpieza del filtro de aire Problema Causa Posible SolucionesLocalización y Solución de Averías Orientación de la corriente de aireExcepciones Cómo obtener servicio o piezas bajo la garantíaGarantía del acondicionador de aire GarantiaCordon électrique avec dispositif de détection darc Risque de choc électriqueAvertissement Pose dans une fenêtre de largeur normale Dimensions de l’appareil et de la fenêtreCaractéristiques des fenêtres Fixation des panneaux de remplissagePose dans une fenêtre de largeur minimum Commande de la vitesse de ventilation Commande marche/arrêtCommandes de la température et du nombre d’heures Commande du modeTélécommande de Climatiseur Commande de la minuterieNettoyage du filtre à air Symptôme Causes possibles SolutionsPRECAUTION´ Orientation de l’air800 332-6658 ou en écrivant à Pour les modèles installés en dehors de l’Amérique du NordGarantie du climatiseur Dépannage ET GarantiePage 23-23-0321N-011

A7Q08F2B specifications

The Fedders A7Q08F2B is a versatile and efficient air conditioning unit designed to provide optimal comfort in residential and small commercial spaces. It stands out for its innovative technologies and user-friendly features, making it a reliable choice for consumers looking to enhance their indoor climate.

One of the key features of the A7Q08F2B is its powerful cooling capacity. With a cooling output of 8,000 BTUs, it effectively cools rooms measuring up to 350 square feet, ensuring a pleasant environment even during the hottest months. The unit also offers multiple fan speeds, allowing users to customize airflow according to their preferences.

Energy efficiency is another major highlight of the Fedders A7Q08F2B. The unit is equipped with an Energy Efficiency Ratio (EER) that meets and often exceeds regulatory standards. This means it uses less electricity without sacrificing performance, resulting in lower utility bills and a smaller carbon footprint. The energy-saving features also include a programmable timer and eco-friendly cooling mode, which further enhance its efficiency.

The design of the A7Q08F2B emphasizes user convenience. It includes a remote control that allows users to adjust settings from across the room, making it incredibly easy to operate. Additionally, the unit features an LED display, enabling instant feedback on temperature settings and operating modes.

The A7Q08F2B also focuses on air quality, incorporating a washable air filter that effectively traps dust, pet dander, and other airborne particles. This not only ensures cleaner air but also promotes healthier living conditions. The filter is easily accessible, requiring minimal effort for maintenance and cleaning.

In terms of installation, the Fedders A7Q08F2B is designed for straightforward setup, compatible with window installations. The detailed installation manual and included mounting hardware make it easier for homeowners to have the unit up and running quickly.

Overall, the Fedders A7Q08F2B encapsulates efficiency, ease-of-use, and effective cooling performance. With its advanced features and commitment to energy conservation, it remains a popular choice for those seeking reliable air conditioning solutions. Whether for a home office, bedroom, or small living area, this unit delivers the comfort and convenience needed for modern lifestyles.
Top Page Image Contents