Grizzly G0612 owner manual Fence Angle Stops, To set the 90º stop

Page 21

Fence Angle Stops

You can quickly set the fence angle at 90º (per- pendicular to the tables), 45º inward, and 45º out- ward. This section provides instructions for setting the fence stops precisely at these angles.

Before making these adjustments, take a moment to identify the various stop parts of the fence bracket assembly (see Figure 23).

Limit Block

 

Limit Block

Forward Tab

 

Rear Slot

 

 

 

Limit

 

 

 

Block Set

 

 

 

Screw

Limit Block

Jam

Inward Stop

Shaft

 

 

Nut

 

 

 

Figure 23. Fence stop parts identification.

To set the 90º stop:

1.DISCONNECT THE JOINTER FROM THE POWER SOURCE!

2.With the fence positioned over the bed and the with the sliding handle locked, loosen the fence tilting handle.

3.Press the forward tab of the limit plate into the rear slot of the limit block.

4.Pull the fence as far as it will go towards 90º (perpendicular to the table), then tighten the fence tilting handle.

Note: When you pull the fence towards 90º, it will stop when it hits the limit block shaft.

5.Use a machinist's combination square to check the angle of the fence as shown in Figure 24.

Figure 24. Checking the 90º stop.

—If the fence is perpendicular to the table according to the machinist's square, the 90º stop is set correctly; move ahead to set the 45º stops.

—If the fence is not perpendicular to the table, adjust the 90º stop by doing Steps 6-9.

G0612 6" Jointer

-19-

Image 21
Contents Model G0612 Jointer Page Table of Contents Introduction ForewordContact Info Machine Data Sheet Identification Safety Instructions for Machinery SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Jointers 110V Operation Circuit RequirementsSetup Safety Unpacking SetupItems Needed for Setup QtyJointer Box Contents Qty InventoryHardware Not Shown Qty Cleanup Site ConsiderationsMounting the Jointer Attaching the Fence Support Components and Hardware Needed QtyTo attach the fence support Installing the Fence To install the fenceFence Tilting Handle To adjust the height of the cutterhead knives Checking Outfeed Table AlignmentTo check the outfeed table alignment Dust Collection To Install the dust collection chute and bagAttaching the dust collection bag Test RunOperation Safety OperationsBasic Parts Controls Page To set the 90º stop Fence Angle StopsTo set the inward 45º stop Adjusting the inward stop G0612 6 JointerTo set the outward 45º stop Stock Inspection Requirements Squaring Stock To surface plane on the jointer Surface PlaningTo edge joint on the jointer Edge JointingTo bevel cut on the jointer Bevel CuttingH1298 AccessoriesH1300 G7984 H2347 H0736 G3631-Jointer/Planer Knife HoneHalf-mask respirator and disposable Cartridge filters H1411-PowerHandsSafety StickCleaning MaintenanceSchedule BeltsTroubleshooting ServicePage Adjusting/Replacing Belts To realign or replace the cutterhead beltTo replace the fan belt To replace motor brushes Replacing Motor BrushesWiring Diagram Parts Breakdown Parts List Description Safety Label Parts ListWarranty and Returns Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog