Grizzly G0612 owner manual Squaring Stock

Page 25

Squaring Stock

Squaring stock involves four steps performed in the order below:

1.Surface Plane on the Jointer—The concave face of the workpiece is surface planed flat with the jointer.

3.Edge Joint 0n the Jointer—The concave edge of the workpiece is jointed flat with the jointer.

4.Rip Cut on a Table Saw—The jointed edge of the workpiece is placed against a table saw fence and the opposite edge cut off.

2.Surface Plane on a Thickness Planer—The opposite face of the workpiece is surface planed flat with a thickness planer.

Previously

Surface

Planed Face

��

��

��

Previously

Jointed Edge

G0612 6" Jointer

-23-

Image 25

Contents Model G0612 Jointer Page Table of Contents Foreword IntroductionContact Info Machine Data Sheet Identification Safety Instructions for Machinery SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Jointers 110V Operation Circuit RequirementsSetup Safety Unpacking SetupItems Needed for Setup QtyInventory Jointer Box Contents QtyHardware Not Shown Qty Site Considerations CleanupMounting the Jointer Components and Hardware Needed Qty Attaching the Fence SupportTo attach the fence support To install the fence Installing the FenceFence Tilting Handle Checking Outfeed Table Alignment To adjust the height of the cutterhead knivesTo check the outfeed table alignment Dust Collection To Install the dust collection chute and bagAttaching the dust collection bag Test RunOperations Operation SafetyBasic Parts Controls Page To set the 90º stop Fence Angle StopsTo set the inward 45º stop Adjusting the inward stop G0612 6 JointerTo set the outward 45º stop Stock Inspection Requirements Squaring Stock To surface plane on the jointer Surface PlaningTo edge joint on the jointer Edge JointingTo bevel cut on the jointer Bevel CuttingH1298 AccessoriesH1300 G7984 H2347 H0736 G3631-Jointer/Planer Knife HoneHalf-mask respirator and disposable Cartridge filters H1411-PowerHandsSafety StickCleaning MaintenanceSchedule BeltsTroubleshooting ServicePage To realign or replace the cutterhead belt Adjusting/Replacing BeltsTo replace the fan belt To replace motor brushes Replacing Motor BrushesWiring Diagram Parts Breakdown Parts List Description Safety Label Parts ListWarranty and Returns Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog