Grizzly G0612 owner manual Test Run, Attaching the dust collection bag

Page 18

2.Slip the bag clamp over the collection bag, then attach the collection bag to the chute and clamp it as shown in Figure 20.

Bag

Clamp

Figure 20. Attaching the dust collection bag.

Test Run

Before you begin operations, do Steps 1-7below to make sure your jointer is running properly.

Loose hair and cloth- ing could get caught in machinery and cause serious personal inju- ry. Keep loose clothing rolled up and long hair tied up and away from machinery.

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly and operation.

To test run your jointer:

1.Read the entire instruction manual first!

-16-

2.Make sure the cutterhead guard fully covers the cutterhead.

3.Make sure all tools and foreign objects have been removed from the machine.

4.Review SECTIONS 1 and 2 (SAFETY and CIRCUIT REQUIREMENTS) on Pages 5- 8 and connect your machine to the power source.

5.Turn the jointer ON.

—The jointer should run smoothly with little or no vibration.

—Immediately stop the jointer if you suspect any problems. Refer to Pages 31 & 32 to troubleshoot and fix any problems before starting the jointer again.

6.Turn the jointer OFF, then remove the safety key from the ON/OFF paddle switch.

7.Lift the paddle switch to the ON position.

—If the jointer motor does not start, then the safety key is working properly and you have finished the test run.

—If the jointer motor starts when the safety key is removed, IMMEDIATELY DISCONNECT THE JOINTER FROM THE POWER SOURCE. Refer to Pages 32 & 33 to troubleshoot the problem.

—If you still cannot solve this or any other problem that arises during the test run, call Grizzly Tech Support at (570) 546-9663.

G0612 6" Jointer

Image 18
Contents Model G0612 Jointer Page Table of Contents Introduction ForewordContact Info Machine Data Sheet Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Jointers Circuit Requirements 110V OperationItems Needed for Setup SetupSetup Safety Unpacking QtyJointer Box Contents Qty InventoryHardware Not Shown Qty Cleanup Site ConsiderationsMounting the Jointer Attaching the Fence Support Components and Hardware Needed QtyTo attach the fence support Installing the Fence To install the fenceFence Tilting Handle To adjust the height of the cutterhead knives Checking Outfeed Table AlignmentTo check the outfeed table alignment To Install the dust collection chute and bag Dust CollectionTest Run Attaching the dust collection bagOperation Safety OperationsBasic Parts Controls Page Fence Angle Stops To set the 90º stopAdjusting the inward stop G0612 6 Jointer To set the inward 45º stopTo set the outward 45º stop Stock Inspection Requirements Squaring Stock Surface Planing To surface plane on the jointerEdge Jointing To edge joint on the jointerBevel Cutting To bevel cut on the jointerH1300 G7984 H2347 H0736 AccessoriesH1298 G3631-Jointer/Planer Knife HoneH1411-PowerHandsSafety Stick Half-mask respirator and disposable Cartridge filtersSchedule MaintenanceCleaning BeltsService TroubleshootingPage Adjusting/Replacing Belts To realign or replace the cutterhead beltTo replace the fan belt Replacing Motor Brushes To replace motor brushesWiring Diagram Parts Breakdown Parts List Safety Label Parts List DescriptionWarranty and Returns Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WAPage Call Today For a Free Full Color Catalog