Grizzly G0612 Half-mask respirator and disposable Cartridge filters, H1411-PowerHandsSafety Stick

Page 30

H2499—Small Half-Mask Respirator

H3631—Medium Half-Mask Respirator

H3632—Large Half-Mask Respirator

H3635—Disposable Cartridge Filter Pair P100

Wood dust is a known carcinogen and has been linked to nasal cancer and severe respiratory ill- nesses. If you work around dust everyday, a half- mask respirator can be a lifesaver. Also compat- ible with safety glasses!

Figure 42. Half-mask respirator and disposable

cartridge filters.

G9256—6" Dial Caliper

G9257—8" Dial Caliper

G9258—12" Dial Caliper

Required for jointing, planing, or sanding to criti- cal tolerances. These traditional dial calipers are accurate to 0.001" and can measure outside surfaces, inside surfaces, and heights/depths. Features stainless steel, shock resistant construc- tion and a dust proof display. An absolute treat for the perfectionist!

Figure 43. Grizzly® Dial Calipers.

-28-

H1411—PowerHands™Safety Stick

This safety push stick features interchangeable traction treads; one for flat stock, and one for pressing against table and fence. It also has a spring loaded push-pin for full workpiece contact. Made in the USA.

Figure 44. H1411 PowerHands™ Safety Stick.

G9643—8" Precision Straightedge

G9644—12" Precision Straightedge

H2675—16" Precision Straightedge

These grade 00 heavy-duty stainless steel straightedges are manufactured to DIN874 stan- dards for professional results in set-up and inspection work.

Figure 45. Straightedges.

G0612 6" Jointer

Image 30

Contents Model G0612 Jointer Page Table of Contents Introduction ForewordContact Info Machine Data Sheet Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Jointers Circuit Requirements 110V OperationItems Needed for Setup SetupSetup Safety Unpacking QtyJointer Box Contents Qty InventoryHardware Not Shown Qty Cleanup Site ConsiderationsMounting the Jointer Attaching the Fence Support Components and Hardware Needed QtyTo attach the fence support Installing the Fence To install the fenceFence Tilting Handle To adjust the height of the cutterhead knives Checking Outfeed Table AlignmentTo check the outfeed table alignment To Install the dust collection chute and bag Dust CollectionTest Run Attaching the dust collection bagOperation Safety OperationsBasic Parts Controls Page Fence Angle Stops To set the 90º stopAdjusting the inward stop G0612 6 Jointer To set the inward 45º stopTo set the outward 45º stop Stock Inspection Requirements Squaring Stock Surface Planing To surface plane on the jointerEdge Jointing To edge joint on the jointerBevel Cutting To bevel cut on the jointerH1300 G7984 H2347 H0736 AccessoriesH1298 G3631-Jointer/Planer Knife HoneH1411-PowerHandsSafety Stick Half-mask respirator and disposable Cartridge filtersSchedule MaintenanceCleaning BeltsService TroubleshootingPage Adjusting/Replacing Belts To realign or replace the cutterhead beltTo replace the fan belt Replacing Motor Brushes To replace motor brushesWiring Diagram Parts Breakdown Parts List Safety Label Parts List DescriptionWarranty and Returns Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WAPage Call Today For a Free Full Color Catalog