Grizzly G0612 owner manual Maintenance, Schedule, Belts, Cleaning, Lubrication

Page 31

SECTION 6: MAINTENANCE

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.

Schedule

For optimum performance from your machine, follow this maintenance schedule and refer to any specific instructions given in this section.

Daily Check

Vacuum all dust on and around the machine.

Empty debris from the dust collection bag. DO NOT use the jointer if debis obstructs the flow of material into the bag. Using the jointer when the chute is obstructed can lead to jointer malfuction and, possibly, fire. Failure to heed this warning can result in serious personal injury.

Wipe down tables and all other unpainted cast iron with a metal protectant.

Monthly Check

Fence angle stops and cutterhead knife alignment.

Belt tension, damage, or wear.

Clean/vacuum dust from inside the cabinet and around the motor.

G0612 6" Jointer

Belts

Belts must be in good condition (free from cracks, fraying and wear), and correctly adjusted. Replacement belts can be ordered from Grizzly. The part number for the cutterhead drive belt is P0612070. The part number for the fan belt is P0612092.

Cleaning

Cleaning the Model G0612 is easy and should be done often. Vacuum excess wood chips and sawdust, and wipe off the remaining dust away with a dry cloth. If any resin has built up, use a resin dissolving cleaner to remove it.

Protect the unpainted cast iron surfaces on the table by wiping the table clean after every use— this will help prevent moisture from wood dust accumulating on bare metal surfaces.

Keep tables rust-free with regular applications of products like G96® Gun Treatment, SLIPIT®, or Boeshield® T-9.

Lubrication

All bearings are sealed and permanently lubri- cated. Do not lubricate them; leave them alone until they need to be replaced.

-29-

Image 31
Contents Model G0612 Jointer Page Table of Contents Foreword IntroductionContact Info Machine Data Sheet Identification Safety Instructions for Machinery SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Jointers 110V Operation Circuit RequirementsQty SetupSetup Safety Unpacking Items Needed for SetupInventory Jointer Box Contents QtyHardware Not Shown Qty Site Considerations CleanupMounting the Jointer Components and Hardware Needed Qty Attaching the Fence SupportTo attach the fence support To install the fence Installing the FenceFence Tilting Handle Checking Outfeed Table Alignment To adjust the height of the cutterhead knivesTo check the outfeed table alignment Dust Collection To Install the dust collection chute and bagAttaching the dust collection bag Test RunOperations Operation SafetyBasic Parts Controls Page To set the 90º stop Fence Angle StopsTo set the inward 45º stop Adjusting the inward stop G0612 6 JointerTo set the outward 45º stop Stock Inspection Requirements Squaring Stock To surface plane on the jointer Surface PlaningTo edge joint on the jointer Edge JointingTo bevel cut on the jointer Bevel CuttingG3631-Jointer/Planer Knife Hone AccessoriesH1298 H1300 G7984 H2347 H0736Half-mask respirator and disposable Cartridge filters H1411-PowerHandsSafety StickBelts MaintenanceCleaning ScheduleTroubleshooting ServicePage To realign or replace the cutterhead belt Adjusting/Replacing BeltsTo replace the fan belt To replace motor brushes Replacing Motor BrushesWiring Diagram Parts Breakdown Parts List Description Safety Label Parts ListWarranty and Returns Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog