GENERAL INFORMATION
Plate Compactor
The Mikasa MVC98D2 is a
Compactor Components
This plate compactor is comprised of an
Vibratory Plates
The vibratory plates of the MVC98D2 produce low amplitude high frequency vibrations, designed to compact granular soils and asphalt.
The resulting vibrations cause forward motion.The engine and handle are vibration isolated from the vibrating plate.The heavier the plate, the more compaction force it generates.
Power Transfer
The Mikasa MVC98D2 Plate Compactor is equipped with an air- cooled, vertical
Engine shaft speed is transfered via engine pulley and
The generated vibration created from the eccentric rotor is transmitted to the compacting plate. This vibration causes the compactor to move in a forward direction.
Frequency/Speed
The compactor's vibrating plate maximum frequency is 6,000 vpm (vibrations per minute).The forward and reverse travel speed of the compactor is approximately 72 ft./minute (22 meters/ minute).
Water Sprinkler System
The water sprinkler system will provide about 20 minutes of sprinkling with the water cock in the full open position and the compactor operating at full speed. It is suggested to mix a small amount of detergent or diesel fuel with water.This will allow the water to the flow much easier.
Controls
Before starting the MVC98D2 Plate Compactor, identify and understand the function of the controls and components as indicated in Figure 2.
MVC98D2 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #1 (1/12/11) — PAGE 13