Maintenance, Daily Service | Multiquip MVC98D2 instruction

Multiquip MVC98D2 manual Inspection and Maintenance ServiceTables, Daily Service

MAINTENANCE

CAUTION

Inspection and other services should always be carried out on hard and level ground with the engine shutdown.

Inspection and Maintenance ServiceTables.

To make sure your plate compactor is always in good working condition before using, carry out the maintenance inspection in accordance with Tables 5 through 7.

TABLE 5. MVC-98D2 MACHINE

INSPECTION

	ITEM	HOURS OF
	ITEM	OPERATION
		OPERATION

	Loose or Missing	Every 8 hours (every
	Screws	day)

	Damaged Parts	Every 8 hours (every
	Damaged Parts	day)
		day)

	V-Belt	Every 200 hours
	Check/Replacement	Every 200 hours
	Check/Replacement

	Clutch Check	Every 200 hours

	Vibrator Oil Check	Every 100 hours

	Vibrator Oil	Every 300 hours
	Replacement	Every 300 hours
	Replacement

	Clutch Check	Every 200 hours

NOTICE

These inspection intervals are for operation under normal conditions.Adjustyour inspection intervals based on the number hours plate compactor is in use, and particular working conditions. Fuel piping and connections should be replaced every 2 years.

TABLE 6. MVC-98D2 ENGINE CHECK

	ITEM	HOURS OF OPERATION

	Oil or Fuel Leak	Every 8 hours (every day)

	Tightness of Fastening	Every 8 hours (every day)
	Threads	Every 8 hours (every day)
	Threads

	Engine Oil Check and	Every 8 hours (every day)
	Engine Oil Check and	(Replenish to specified maximum
	Replenishment	(Replenish to specified maximum
	Replenishment	level)
		level)

	Engine Oil Replacement	After first 25 hours then every 50 to
	Engine Oil Replacement	100 hours
		100 hours

	Air Filter Cleaning	Every 100 hours

See separate engine manual for details on engine maintenance.

Daily Service

Check for leakage of fuel or oil.

Check for loose screws including tightness. See Table 7 below (tightening torque ), for retightening:

TABLE 7.

TIGHTENING TORQUE (in. kg/cm) Diameter

Material	6mm	8mm	10mm	12mm	14mm	16mm	18mm	20mm

4T	70	150	300	500	750	1,100	1,400	2,000

6-8T	100	250	500	800	1,300	2,000	2,700	3,800

11T	150	400	800	1,200	2,000	2,900	4,200	5,600

*	100	300~	650 ~
*	100	350	700
		350	700

* (In case counter-part is of aluminum)

(Threads in use with this machine are all right handed)

Material and quality of material is marked on each bolt, and screw.

Remove soil and clean the bottom of compaction plate.

Check vibrating case for any oil leakage.

Check engine oil.

MVC98D2 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #1 (1/12/11) — PAGE 21