MAINTENANCE
REMOVE
VIBRATOR
REMOVE
Figure 20. V-Belt Check
Vibrating Case Oil Replacement (300 Hours)
CAUTION
Always clean the area around the vibrator oil plug (oil level check) hole before removing plug.This will prevent dirt and debris from entering the system.
1.Place the plate compactor horizontally on a flat surface.
2.Remove oil drain plug (Figure 21) from vibrator and drain oil from the vibrating case.
3.Using a funnel, fill vibrating case with
4.
Checking and Replacing the Clutch
Checking the Clutch
1.With belt cover removed, visually check outer drum of the clutch for seizure and "V" groove for wear or damage.
2.Clean the "V" groove as necessary.
3.Check the clutch lining and shoe for signs of wear. If the shoe is worn, replace the clutch to prevent deficient power transmission and slippage.
Replacing the Clutch
1.Place a 19 mm offset wrench or the like onto the lower vibrator pulley fastening bolt.
2.While pulling back hard on the
3.Remove bolt at engine power output by giving a shock to an engaged wrench (e.g. tapping with hammer) and rotate the bolt counterclockwise.
4.Remove clutch with a pulley extractor.
5.To install a new clutch, reverse steps
Figure 21. Oil Level Check Plug
MVC98D2 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #1 (1/12/11) — PAGE 23