Maintenance Instructions
Repairs:
This unit is not user servicable. The unit must be returned to the factory for prompt repair and calibration. This gun is equipped with a temperature cutout device intended to shut off power to the gun if set internal temperatures are exceeded. If gun doesn’t function, please refer to our warranty repair page in this booklet for additional information.
Please refer to our warranty repair page in this booklet (p8) for additional information.
Note:
Always unplug your tool before cleaning.
Heating Elements: Heating element abuse and eventual burnout can occur from one of the following conditions:
1)Improper line voltage
2)Improper attachment
3)Nozzle too close to work being heated (less than 1 inch).
Lubrication
Bearings are lubricated at tfactory and require no further lubrication.
Cleaning:
Unplug heat gun before cleaning. To clean outside of tool, use only a mild soap and damp cloth. Do not use other cleaning agents, turpentine, gasoline, lacquer or paint thinner, or other solvents that may contain chemicals which are harmful to plastics and other insulating materials. Never immerse tool in a liquid or allow a liquid to enter inside the tool. Make sure all vents and openings are free and clear of debris.
Accessories/Attachments
35016 | 35017 | |
Spreader attachment |
| Heat shrink attachment |
|
|
|
35289 | 35292 | |
Raychem |
| Specalty connector |
|
| attachment |
| ||
|
|
|
35294 | 35216 | |
5/16” reducer |
| bench stand |
Users should independently evaluate the suitability of the product for their application.
35026
Nozzle Shield
35293
9/16” reducer
35309
Attachment Kit
5 of our most popular
application tips
7