Grizzly G0526 instruction manual Belt, To install the V-belt

Page 19

V-Belt

Components and Hardware Needed: Qty

V-Belt A-54

1

Tools Needed:

 

12mm Wrench or Socket

1

Straightedge

1

To install the V-belt:

 

1.Remove the back access panel from the join- ter stand.

2.Using a 12mm wrench, loosen the motor mount bolts. NoteÑDO NOT completely remove the motor mount bolts.

3.Slide the motor upward far enough to allow the V-belt to be placed around the cutterhead pulley and the motor pulley.

4.Carefully allow the motor to slide downward, tensioning the V-belt with the weight of the motor.

5.Using a straightedge, check the alignment of the V-belt and the two pulleys (Figure 14).

Figure 14. The V-belt should be in alignment

with the two pulleys.

ÑIf the V-belt is aligned between the pul- leys, continue on to step 7.

ÑIf the V-belt is NOT aligned between the pulleys, continue with the next step.

6.Adjust the motor until the V-belt is aligned between the pulleys. NoteÑThe pulleys can also be adjusted in and out along the motor shaft and cutterhead shaft by loosening the pulley setscrews.

7.Tighten the motor mount bolts loosened in step 1

G0526 6" Jointer

-17-

Image 19
Contents Jointer Page Table Of Contents Service Adjustments Safety Instructions For Power Tools SafetyLength Never Joint end grain Additional Safety Instructions For JointersCommentary IntroductionAmperage Draw Circuit RequirementsAmperage Draw Plug-Type Circuit BreakerCircuit Capacity Extension Cords Rewiring ToGrounding External Features Machine FeaturesCommon Terms & Definitions About This Section Parts Inventory SET UPUnpacking Jointer mounting hardware Bag contents Cutterhead guard bag contents Circle Working Clearances Clean Up Site ConsiderationsTools Needed Beginning Assembly Jointer To StandBelt To install the V-beltTo attach the fence assembly To install the dust portDust Port Fence To install the V-belt guard To install the cutterhead guardCutterhead Guard Belt Guard To install the pedestal switch Pedestal Switch HandwheelsTo install the handwheels Factory adjustments that should be verified Start Up Recommended AdjustmentsGeneral OperationsStock Inspection & Requirements Squaring Stock Minimum dimensions For edge jointingIllustration of surface planing results Surface PlaningIllustration of edge jointing results Edge JointingIllustration of bevel cutting results Bevel CuttingIllustration of rabbet cutting effects A few sample joints Rabbet CuttingBefore each use, look for the following condi- tions MaintenanceMaintenance Safety Personal injuryCarbide Cutters BeltsLubricationDate Approximate Hours Of Use Maintenance Performed Maintenance LogAbout Service Service AdjustmentsOutfeed Table Height To set the depth-of-cut scale Depth-Of-Cut Scale Fence StopsTo set the 45˚ inward fence stop To set the 45˚ outward fence stop To set the 90˚ fence stopInstalling or adjusting a carbide cutter Adjusting Gibs Carbide CuttersTo set the table gibs Reference Info Aftermarket AccessoriesMachine Data Sheet G0526 6 Jointer Description Fence Spiral Cutterhead 307303 308 309 302 310 312 311A 313 Cabinet Stand Troubleshooting Guide Board has excessive bow or twist along G0526 Wiring Diagram Warranty & Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog