Grizzly G0526 instruction manual Service Adjustments, About Service, Outfeed Table Height

Page 33

SECTION 8: SERVICE ADJUSTMENTS

!	Always	disconnect
	power	to the machine
	before	performing ser-
	vice adjustments. Failure
	to do this may result in
	serious personal injury.

About Service

This section is designed to help the operator with adjustments that were made at the factory and that might also need to be made during the life of the machine.

This section is provided for your convenienceÑit is not a substitute for the Grizzly Service Department. If any adjustments arise that are not described in this manual, then feel free to call the Grizzly Service Department at (570) 546-9663.

Similarly, if you are unsure of how to perform any procedure in this section, the Grizzly Service Department will be happy to guide you through the procedures or help in any other way.

Outfeed Table

Height

The outfeed table must be level with the carbide cutters when they are at top-dead-center.

To set the outfeed table height:

1.Place a straightedge on the outfeed table so it extends over the cutterhead.

2.Rotate the cutterhead pulley until one of the carbide cutters is at top-dead-center.

3.Raise or lower the outfeed table until the car- bide cutter just touches the straightedge (Figure 28).

Figure 28. Setting the outfeed table height.

G0526 6" Jointer

-31-

Image 33

Contents Jointer Page Table Of Contents Service Adjustments Safety Instructions For Power Tools SafetyLength Never Joint end grain Additional Safety Instructions For JointersCommentary IntroductionAmperage Draw Plug-Type Circuit RequirementsCircuit Breaker Amperage DrawRewiring To Circuit Capacity Extension CordsGrounding External Features Machine FeaturesCommon Terms & Definitions SET UP About This Section Parts InventoryUnpacking Jointer mounting hardware Bag contents Cutterhead guard bag contents Circle Working Clearances Clean Up Site ConsiderationsTools Needed Beginning Assembly Jointer To StandBelt To install the V-beltTo install the dust port To attach the fence assemblyDust Port Fence To install the cutterhead guard To install the V-belt guardCutterhead Guard Belt Guard Pedestal Switch Handwheels To install the pedestal switchTo install the handwheels Factory adjustments that should be verified Start Up Recommended AdjustmentsOperations GeneralStock Inspection & Requirements Squaring Stock Minimum dimensions For edge jointingIllustration of surface planing results Surface PlaningIllustration of edge jointing results Edge JointingIllustration of bevel cutting results Bevel CuttingIllustration of rabbet cutting effects A few sample joints Rabbet CuttingMaintenance Safety MaintenancePersonal injury Before each use, look for the following condi- tionsCarbide Cutters BeltsLubricationDate Approximate Hours Of Use Maintenance Performed Maintenance LogService Adjustments About ServiceOutfeed Table Height Depth-Of-Cut Scale Fence Stops To set the depth-of-cut scaleTo set the 45˚ inward fence stop To set the 45˚ outward fence stop To set the 90˚ fence stopAdjusting Gibs Carbide Cutters Installing or adjusting a carbide cutterTo set the table gibs Reference Info Aftermarket AccessoriesMachine Data Sheet G0526 6 Jointer Description Fence Spiral Cutterhead 307303 308 309 302 310 312 311A 313 Cabinet Stand Troubleshooting Guide Board has excessive bow or twist along G0526 Wiring Diagram Warranty & Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog