Grizzly G0526 Start Up Recommended Adjustments, Factory adjustments that should be verified

Start Up	Recommended
	Adjustments

Loose hair and clothing could get caught in machinery causing seri- ous personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly and operation.

Starting the machine:

1.Read the entire instruction manual.

2.Make sure the cutterhead guard is installed and correctly adjusted (Page 19).

3.Make sure all tools and foreign objects have been removed from the machine.

4.Review Section 3: Circuit Requirements (Page 7).

5.Keep your finger on the STOP button at all times during the test run.

Starting the machine:

Press the START button to turn the machine ON. The machine should run smoothly with little or no vibration.

For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.

However, because of the many variables involved with shipping, we recommend that you at least verify the following adjustments to ensure the best possible results from your new machine.

Step-by-step instructions on verifying these adjustments can be found in Section 8: Service Adjustments.

Factory adjustments that should be verified:

1.Outfeed Table Height (page 31)

2.Depth-of-Cut Scale (page 32)

3.Fence Stops (page 32)

G0526 6" Jointer -21-