Grizzly G0526 instruction manual Depth-Of-Cut Scale Fence Stops, To set the depth-of-cut scale

Page 34

Depth-Of-Cut Scale

 

Fence Stops

 

 

 

 

 

 

To set the depth-of-cut scale:

1.Set the outfeed table height as described in the ÒOutfeed Table HeightÓ sub-section.

2.Place a straightedge across the infeed and outfeed tables

3.Adjust the infeed table until it is level with the outfeed table.

4.Adjust the depth-of-cut pointer to read Ò0Ó (Figure 29).

Figure 29. Depth-of-cut pointer adjusted to Ò0Ó position.

The fence stops are adjustable nuts and bolts that simplify the task of adjusting the fence to 45û inward, 90û, and 45û outward (135û).

To set the 45˚ inward fence stop :

1.Using a 45û square, adjust the fence to the 45û inward position.

2.Loosen the jam nut shown in Figure 30.

Fence Stop Nut

Jam Nut

Figure 30. 45û inward fence stop jam nut.

3.Adjust the 45û inward fence stop nut until it makes contact with the back of the fence bracket.

4.Retighten the jam nut loosened in step 2.

-32-

G0526 6" Jointer

Image 34
Contents Jointer Page Table Of Contents Service Adjustments Safety Safety Instructions For Power ToolsLength Additional Safety Instructions For Jointers Never Joint end grainIntroduction CommentaryCircuit Breaker Circuit RequirementsAmperage Draw Plug-Type Amperage DrawCircuit Capacity Extension Cords Rewiring ToGrounding Machine Features External FeaturesCommon Terms & Definitions About This Section Parts Inventory SET UPUnpacking Jointer mounting hardware Bag contents Cutterhead guard bag contents Circle Clean Up Site Considerations Working ClearancesBeginning Assembly Jointer To Stand Tools NeededTo install the V-belt BeltTo attach the fence assembly To install the dust portDust Port Fence To install the V-belt guard To install the cutterhead guardCutterhead Guard Belt Guard To install the pedestal switch Pedestal Switch HandwheelsTo install the handwheels Start Up Recommended Adjustments Factory adjustments that should be verifiedGeneral OperationsStock Inspection & Requirements Minimum dimensions For edge jointing Squaring StockSurface Planing Illustration of surface planing resultsEdge Jointing Illustration of edge jointing resultsBevel Cutting Illustration of bevel cutting resultsRabbet Cutting Illustration of rabbet cutting effects A few sample jointsPersonal injury MaintenanceMaintenance Safety Before each use, look for the following condi- tionsBeltsLubrication Carbide CuttersMaintenance Log Date Approximate Hours Of Use Maintenance PerformedAbout Service Service AdjustmentsOutfeed Table Height To set the depth-of-cut scale Depth-Of-Cut Scale Fence StopsTo set the 45˚ inward fence stop To set the 90˚ fence stop To set the 45˚ outward fence stopInstalling or adjusting a carbide cutter Adjusting Gibs Carbide CuttersTo set the table gibs Aftermarket Accessories Reference InfoMachine Data Sheet G0526 6 Jointer Description Fence Spiral Cutterhead 307303 308 309 302 310 312 311A 313 Cabinet Stand Troubleshooting Guide Board has excessive bow or twist along G0526 Wiring Diagram Warranty & Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WAPage Call Today For a Free Full Color Catalog