JOINTER
1.Removing the blades
CAUTION :
Always close the chip cover over the
Lower the infeed table fully by turning the depth adjusting knob clockwise. Loosen the hex bolt which secures the safety cover rod and lift off the safety
cover. Set the fence angle a t 0' and push the fence fully toward the auto-
planer. Pull the lock pin and rotate the- drum by turning the knob to lock the
drum in the position whereby the blade installation bolts face upward.
Lock pin
(NOTE)
The drum can be locked in two different positions. One position is where the blade edge faces upward and the other is where the blade installation bolts face upward.
Remove the four blade installation bolts and the drum plate. Place the two mag- netic holders on the set plate. (Note: The magnetic holder has a different shaped claw on each side. Use the cor- rect claw for jointer.) Push them in the direction of the arrow until the claw contact the blade.
Grip the magnetic holders and raise them to remove the set plate and blade from the drum. Pull the lock pin and rotate the drum by turning the knob 180' to lock the drum. Remove the other blade as described above.
15