For Jointer

1.Maintain the proper relationships of infeed and outfeed table surfaces and cutterhead blade path.

2. Do not perform jointing operations on material shorter than 140 m m (5-1/2 inches), narrower than 19 m m ( 3 / 4 inch), or less than 12.7 m m (112 inch) thick.

3.Do not perform planing operations on material shorter than 140 m m (5 - 1/2 inches), narrower than 19 m m ( 3 / 4 inch), wider than 155 m m (6-1/8inches) or thinner than 12.7 m m (112 inch).

4.Support the workpiece adequately at all times during operation; maintain control of the work at all times.

5. Do not back the work toward the infeed table.

6.Do not attempt t o perform an abnormal or little-used operation without study and the use of adequate hold-down/push blocks, jigs, fixtures, stops and the like.

FOR AUTO-PLANER

1.Two or more pieces of narrow but similar thickness stock can be passed through the auto-planer side by side.

However, allow some spacing between the stock t o permit the feed rollers to grip the thinnest piece.

Otherwise, a slightly thinner piece could be kicked back by the cutterhead.

2.Determine the depth of cut according t o the table shown on the front of the tool. Do not attempt t o cut more than the specified amount in one pass.

WARNING

For Your O w n Safety, Read Instruction Manual Before Operating Jointer

1.Wear eye protection.

2.Never perform jointing or planing operation with cutter head or drive guard removed.

3.Never make jointing or planing cut deeper than 3 m m (118 inch).

4.Always use hold-down/push blocks for jointing material narrower than 76 . 2 m m (3inches), or planing material thinner than 76 . 2 m m (3inches).

SAVE THESE INSTRUCTIONS.