Makita 2030S instruction manual Auto-Plane R

Page 12

AUTO-PLANE R

1. Removing the blades

Loosen the hex bolt which secures the

Knob

 

chip cover and open the chip cover.

 

 

Open the safety cover over the jointer

 

 

and rotate the drum by turning the

 

 

knob until the drum can be locked in

 

 

the position whereby the blade installa-

 

 

tion bolts face upward.

 

 

1

Hex bolt

Blad; installation bolt

The magnetic holder has a different

 

 

shaped claw on each side. Use the cor-

 

 

rect claw for auto-planer.

For jointer

Claw

 

 

MMagnetic holder

 

I

 

Place the two magnetic holders on the set plate and push them in the direction of the arrow until the claw contacts the blade. Remove the eight blade installation bolts using the socket wrench. Grip the magnetic holders and raise them straight up to remove the set plate and blade from the drum. Press the lock plate and rotate the drum by turning the knob 180" to lock the drum. Remove the other blade as described above.

-Socket wrench

IBlade installation bolt

LMagnetic holders

12

Image 12
Contents 312 mm 12-9/32MODEL2030s General Safety Precautions Minimum aaae for cord Additional Safety Rules For Jointer & AUTO-PLANER For Jointer Installing the crank handle Switch actionMovement and transport of planer-jointer Positioning the planer-jointerScale-\ Indicator plate Crank h a n d l e d Operation Adjusting the depth of cut Extension support tableAdjusting the fence angle Operation Placement of hands during feedingJointing an edge SurfacingBeveling Replacing the Planer BladesAUTO-PLANE R Installing the blades Page Removing the blades Installing the blades Outfeed table Page Removing or Installing the Jointer Line Ter Maintenance Accessor I ES PLANER-JOINTER Page Page MACHlNE 201 1 Coupling Makita Corporation