Extension support table, Adjusting the depth of cut

JOINTER FUNCTIONS:

Extension support table

The extension support table is convenient

for cutting long workpieces. Install it on I Extension support table 7Hex bolts

the outfeed table and semi-tighten the four hex bolts. Extend the legs and hook the

arms over the screw using the hook (A). Then tighten the screws securely. Adjust the table height using the knobs so that the extension support table i s level with the outfeed table. Then tighten the wing nuts securely. After adjusting the table height, tighten the four hex bolts securely.

When moving the tool, fold the extension
support table as follows.			Hook (A)-,	- 1
First fold the extension support table	as		Hook (A)-,	- 1
First fold the extension support table	as
shown in the figure. Tighten the two hex
bolts securely. While holding the legs,
loosen the screws and unhook the arms
from the screw. Fold the legs and hook the
arms over the screw using the hook (6).
Then tighten the screws securely.
		I	VI
		I	x e H	;
			x e H	;

Adjusting the depth of cut

Arm

Screw

bolt

The depth of cut can be adjusted from 0 mm to 3 mm (1/8"). Align the pointer to the desired graduation on the scale plate by turning the depth adjusting knob. The in- feed table i s lowered for increased depth of cut by turning it clockwise and raised by turning it counterclockwise.

Scale plate 1 L Depth adjusting knob