127
Appendices
Problem Cause Solution
The subject comes
out overexposed
(too bright).
The subject is too close to the flash. • When flash is used, the distance between
lens and subject should be no less than 20
cm (7.9 in.).
The subject is brighter than the
surroundings.
• Set exposure compensation to a negative
value.
Light is shining or reflecting into the camera.
• Adjust the camera angle.
The flash mode is set so that the flash
always fire.
• Set the flash to any other mode except on.
White dots or white
asterisks appear on
the image.
Light from the flash has reflected off
dust particles or insects in the air.
• This is a phenomenon that occurs with
digital cameras and does not constitute a
malfunction.
A red bar of light
appears on the LCD
monitor.
The subject is too bright. • This is normal occurrence in devices
containing CCDs and does not constitute a
malfunction. (This red bar of light will not be
recorded when shooting still photos, but it
will be recorded when shooting movies.)
The flash doesn't
fire.
The flash mode is set to flash off mode. Set the flash mode to any other mode
except Off.
Reading images from
CF card is slow.
Recording images to
CF card takes a long
time.
CF card was formatted in another
device.
• Use a CF card formatted in your camera.
See "Formatting a CF Card" (p. 78).