MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
Replacingcarbon brushesc Remove and check the carbon brushes re- 1
gularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced a t the
same time. Use only indentical carbon L brushes.
Limit mark
Open the chip cover and remove the brush
holder caps using a screwdriver. Take out Brush holder cap the worn carbon brushes, insert the new
ones and secure the brush holder caps.
I
Lubrication
Oil the chain (after removing the side cover R), the column moving parts (contact areas) and the crank handle. This periodic lubrica- tion should be performed with machine oil.
CAUTION :
Oiling and all maintenance should be done with the tool turned off and unplugged.
\
Screwdriver
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance and adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts only.
21