Milwaukee 5314-21 manual Chiseling and Chipping, Bushing Tools, Mortar Cutting Chisels Seam Tools

WARNING!

To reduce the risk of personal injury and damage to the tool or work:

•Always use the “hammering-only” setting to set the anchor. Never use the “hammer- ing-with-rotation” setting to set the anchor.

•Never switch the tool to “hammering-with- rotation” until after the anchor has been set and the tooth anchor chuck has been removed from the anchor.

Setting Self-Drilling Anchors (Fig. 13-18) (Cat. No. 5314-21 only)

The 5314-21 Rotary Hammer features a stop rotation knob which is helpful for setting self-drilling anchors up to 5/8". MILWAUKEE Tooth Anchor Chucks require a “B” taper adapter.

Fig. 13

Fig. 14

1/8"

Fig. 15

Fig. 16

Fig. 17

Fig. 18

1.Place the proper size tooth anchor chuck into the “B” taper adapter. Then insert the “B” taper adapter into the tool and lock it into place as described. See “Installing Bits and Chisels”.

2.Insert the anchor into the tooth anchor chuck. Set the stop rotation knob for hammering only. Set the anchor on your mark and hammer until the teeth have penetrated the concrete (Fig. 13).

3.Set the stop rotation knob for hammering with rotation and drill until the chuck is 1/8" above the concrete (Fig. 14).

NOTE: It may be necessary to clean dust and cuttings from the an- chor several times while drilling the hole.

4.Remove the anchor from the hole while the tool is running. Clean the dust and cuttings from the anchor by pointing it downward and turn- ing the tool on and off several times. Clean the dust out of the hole with a vacuum cleaner or blowout bulb (Fig. 15).

5.Place the expansion plug into the anchor and insert the anchor into the hole. Switch the stop rotation knob back to hammering only, and hammer the anchor firmly into the hole (Fig. 16).

6.Snap the head off of the anchor. To remove the head of anchors up to 5/8", grasp the handles firmly and pull the tool sharply towards you (Fig. 17) or snap off the anchor head with a hand hammer as shown (Fig. 18). The anchor is now ready to receive a bolt.

7.To remove the anchor head wedged in the tooth anchor chuck, use drift pin 48-86-0100.

8.To remove the tooth anchor chuck, remove the “B” taper adapter from the nose of the tool. Insert the drift pin supplied with the adapter into the hole on the side of the “B” taper adapter and strike it sharply to force out the tooth anchor chuck.

Chiseling and Chipping

MILWAUKEE 1-1/2" Rotary Hammers may be used for chipping and chis- eling.

When chiseling, hold the tool at an angle to the workpiece. Work from a corner or close to the edge of the workpiece, breaking off one small area at a time rather than attempting too large an area.

A variety of accessories are available.

Bushing Tools

Used to surface concrete.

Mortar Cutting Chisels (Seam Tools)

For removing old mortar for tuck pointing or caulking.

Bull Points

For demolition work and starting holes in concrete slabs.

Flat Chisels

For edging, chipping or channeling.

Scaling Chisels

For removing weld spatter or scale and cut- ting straight lines.

Slotting Chisel

For slotting and cutting between drilled holes in concrete and masonry.

page 8