Sharp AE-Z48LZ Vacancy Operation, Additional Notes on Operation, Operating Temperature Range

Page 15

VACANCY OPERATION

Heating operation with 10°C set temperature will be performed to protect your home and furniture from frost damage, even when you are out.

1 Press the HEAT button.

2 Press the VACANCY button.

• The remote control will display “ 10°C ”.

1

2

TO CANCEL

Press the VACANCY button again.

ADDITIONAL NOTES ON

OPERATION

OPERATING TEMPERATURE RANGE

 

 

INDOOR TEMP.

OUTDOOR TEMP.

HEATING

upper limit

27˚C

24˚C

lower limit

–20˚C

 

COOLING

upper limit

32˚C

43˚C

lower limit

21˚C

–10˚C

 

The built-in protective device may prevent the unit from operating when used out of this range.

Condensation may form on the air outlet if the unit operates continuously in the COOL or DRY mode when humidity is over 80 percent.

WHEN POWER FAILURE OCCURS

This unit has a memory function to store settings when a power failure occurs.

After power recovery, the unit will automatically re- start in the same settings which were active before the power failure, except for timer settings.

If the timers were set before a power failure, they will need to be re-set after power recovery.

PREHEATING FUNCTION

In the HEAT operation, the indoor fan may not start for two to five minutes after the unit is turned on to prevent cold air from blowing out of the unit.

DE-ICING FUNCTION

When ice forms on the heat exchanger in the outdoor unit during the HEAT operation, an automatic de-icer provides heat for about 5 to 10 minutes to remove the ice. During de-icing, the inside and outside fans stop operating.

After de-icing is completed, the unit automatically resumes operation in the HEAT mode.

HEATING EFFICIENCY

The unit employs a heat pump that draws heat from the outside air and releases it into the room. The outside air temperature therefore greatly affects the heating efficiency.

If the heating efficiency is reduced due to low outside temperatures, use an additional heater.

It takes time to warm up and heat the entire room because of the forced air circulation system.

13

Image 15
Contents AY-ZP48LZ AE-Z48LZ Page Instructions ContentsImportant Safety Important Safety InstructionsPart Names Indoor UnitOutdoor Unit Transmitter Display Remote Control Remote Control DisplaySET Current Clock Time Using the Remote ControlHOW to USE the Remote Control Loading BatteriesSetting AIR Purifying FIL- TER Auxiliary ModeTips on Saving Energy To turn off the unit, press the Stop button Basic OperationPress the COOL, DRY or Heat button To change the fan speed, press the FAN buttonVertical airflow louvre will swing Adjusting the AIR Flow DirectionVertical AIR Flow Direction Horizontal AIR Flow Direction Press the Swing buttonPress the Coanda Airflow button again Coanda AirflowSpot AIR During operation, press the Coanda Airflow buttonPress the Energy Save button again Full Power Operation Energy Saving OperationDuring operation, press the Full Power button Press the Full Power button againPress the Timer OFF Button Timer OperationPress the 1.2.3.5h OFF Timer button to set the desired time Timer OFFCombined USE of on and OFF Timers Timer onTo Cancel Timer Mode To Change Time SettingDuring operation, press the Plasmacluster button Plasmacluster Operation Self Clean OperationPress the Self Clean button when the unit is not operating Press the Self Clean buttonPress the Heat button Press the Vacancy button Operating Temperature RangeVacancy Operation Additional Notes on OperationMaintenance Following conditions do not denote equip- ment malfunctions Before Calling for ServiceSpecifications Check the following points before calling for servicePage