Sharp AY-ZP48LZ, AE-Z48LZ Spot AIR, During operation, press the Coanda Airflow button

Page 10

COANDA AIRFLOW

In cool or dry mode, the vertical airﬂow louvre is set obliquely upward to deliver cool air to the ceiling in order to avoid direct airﬂow.

In heat mode, the vertical airﬂow louvre is set downward to deliver warm air down to the ﬂoor.

1 During operation, press the COANDA AIRFLOW button.

(HEAT mode)	”.
• The remote control will display “

(COOL / DRY mode)

• The remote control will display “ ”.

1

TO CANCEL

Press the COANDA AIRFLOW button again.

NOTE:

•If you want the COANDA AIRFLOW setting in the FULL POWER mode, press the COANDA AIRFLOW button during the FULL POWER operation.

•The COANDA AIRFLOW setting and the SPOT AIR setting can not be used together.

SPOT AIR

The louvres are adjusted so that air ﬂow is delivered to the desired area.

1 Press the SPOT AIR button to select the desired air ﬂow direction.

CANCEL

1

NOTE:

•If you want the SPOT AIR setting in the FULL POWER mode, press the SPOT AIR button during the FULL POWER operation.

•The COANDA AIRFLOW setting and the SPOT AIR setting can not be used together.

8

Image 10

Contents AY-ZP48LZ AE-Z48LZ Page Important Safety Instructions ContentsImportant Safety InstructionsIndoor Unit Part NamesOutdoor Unit Remote Control Remote Control Display Transmitter DisplayLoading Batteries Using the Remote ControlHOW to USE the Remote Control SET Current Clock TimeAuxiliary Mode Setting AIR Purifying FIL- TERTips on Saving Energy To change the fan speed, press the FAN button Basic OperationPress the COOL, DRY or Heat button To turn off the unit, press the Stop buttonPress the Swing button Adjusting the AIR Flow DirectionVertical AIR Flow Direction Horizontal AIR Flow Direction Vertical airﬂow louvre will swingDuring operation, press the Coanda Airflow button Coanda AirflowSpot AIR Press the Coanda Airflow button againPress the Full Power button again Full Power Operation Energy Saving OperationDuring operation, press the Full Power button Press the Energy Save button againTimer OFF Timer OperationPress the 1.2.3.5h OFF Timer button to set the desired time Press the Timer OFF ButtonTo Change Time Setting Timer onTo Cancel Timer Mode Combined USE of on and OFF TimersPress the Self Clean button Plasmacluster Operation Self Clean OperationPress the Self Clean button when the unit is not operating During operation, press the Plasmacluster buttonAdditional Notes on Operation Operating Temperature RangeVacancy Operation Press the Heat button Press the Vacancy buttonMaintenance Check the following points before calling for service Before Calling for ServiceSpecifications Following conditions do not denote equip- ment malfunctionsPage