Sharp AE-Z48LZ, AY-ZP48LZ Setting AIR Purifying FIL- TER, Tips on Saving Energy, Auxiliary Mode

Page 7

SETTING AIR PURIFYING FIL- TER

The air purifying filters are packed as accessory of this unit. During operation, the filters remove dust and tobacco smoke from the air and discharges clean air.

1 Take out the air filters.

1 Open the open panel.

2Push the air filters up slightly to unlock them.

3Pull the air filters down to remove them.

1

23

2 Set the air purifying filter under the filter stoppers located on the air filter.

Filter stopper

Air purifying filter

Air filter

3 Reinstall the air filters.

1 Reinstall the air filters in the original posi- tions.

2Close the open panel.

2

1

Precautions:

The filters are sealed in a plastic bag to keep their dust collection effect.

Do not open the bag until using the filters. (Otherwise the filters life may be reduced.)

Do not expose the filters to direct sunlight. (Otherwise they may deteriorate.)

TIPS ON SAVING ENERGY

Below are some simple ways to save energy.

SET THE PROPER TEMPERATURE

Setting to higher or lower than necessary temperature point will result in increased power consumption.

BLOCK DIRECT SUNLIGHT AND PREVENT DRAFTS

Blocking direct sunlight during cooling operation will reduce power consumption.

Close the windows and doors during cooling and heating operations.

SET PROPER AIR FLOW DIRECTION TO OBTAIN THE BEST AIR CIRCULATION

KEEP THE FILTER CLEAN TO ENSURE THE MOST EFFICIENT OPERATION

USE THE TIMER OFF FUNCTION WHEN POSSIBLE

TURN OFF THE CIRCUIT BREAKER WHEN THE UNIT IS NOT USED FOR AN EXTENDED PERIOD OF TIME

The indoor unit still consumes a small amount of power when it is not operating.

AUXILIARY MODE

Use this mode when the remote control is not available.

TO TURN ON

Lift the open panel of the indoor unit and press the AUX button.

The red OPERATION lamp ( ) on the unit will light and the unit will start operating in the AUTO mode.

The fan speed and temperature setting are set to AUTO.

TO TURN OFF

Press the AUX button again.

The red OPERATION lamp ( ) on the unit will turn off.

AUX

5

Image 7
Contents AY-ZP48LZ AE-Z48LZ Page Instructions ContentsImportant Safety Important Safety InstructionsIndoor Unit Part NamesOutdoor Unit Transmitter Display Remote Control Remote Control DisplaySET Current Clock Time Using the Remote ControlHOW to USE the Remote Control Loading BatteriesAuxiliary Mode Setting AIR Purifying FIL- TERTips on Saving Energy To turn off the unit, press the Stop button Basic OperationPress the COOL, DRY or Heat button To change the fan speed, press the FAN buttonVertical airflow louvre will swing Adjusting the AIR Flow DirectionVertical AIR Flow Direction Horizontal AIR Flow Direction Press the Swing buttonPress the Coanda Airflow button again Coanda AirflowSpot AIR During operation, press the Coanda Airflow buttonPress the Energy Save button again Full Power Operation Energy Saving OperationDuring operation, press the Full Power button Press the Full Power button againPress the Timer OFF Button Timer OperationPress the 1.2.3.5h OFF Timer button to set the desired time Timer OFFCombined USE of on and OFF Timers Timer onTo Cancel Timer Mode To Change Time SettingDuring operation, press the Plasmacluster button Plasmacluster Operation Self Clean OperationPress the Self Clean button when the unit is not operating Press the Self Clean buttonPress the Heat button Press the Vacancy button Operating Temperature RangeVacancy Operation Additional Notes on OperationMaintenance Following conditions do not denote equip- ment malfunctions Before Calling for ServiceSpecifications Check the following points before calling for servicePage