Sharp AE-Z48LZ, AY-ZP48LZ operation manual Adjusting the AIR Flow Direction, Press the Swing button

Page 9

ADJUSTING THE AIR FLOW DIRECTION

VERTICAL AIR FLOW DIRECTION

HORIZONTAL AIR FLOW DIRECTION

1

Press the SWING button(

).

• The vertical airflow louvre will swing.

 

Press the SWING button(

) again

2 when the vertical airflow louvre is at the desired position.

1

Press the SWING button(

).

• The horizontal airflow louvres will swing.

 

Press the SWING button(

) again

2 when the horizontal airflow louvres are at the desired position.

1

2

1

2

NOTE:

The adjusted position will be memorized and will be automatically set to the same position when operated the next time.

The adjustment range is narrower than the SWING range in order to prevent condensation from dripping.

CAUTION:

Never attempt to adjust the louvres manually.

Manual adjustment of the louvres can cause the unit to malfunction.

When the vertical airflow louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may re- sult.

7

Image 9
Contents AY-ZP48LZ AE-Z48LZ Page Important Safety ContentsImportant Safety Instructions InstructionsPart Names Indoor UnitOutdoor Unit Transmitter Display Remote Control Remote Control DisplayHOW to USE the Remote Control Using the Remote ControlLoading Batteries SET Current Clock TimeSetting AIR Purifying FIL- TER Auxiliary ModeTips on Saving Energy Press the COOL, DRY or Heat button Basic OperationTo change the fan speed, press the FAN button To turn off the unit, press the Stop buttonVertical AIR Flow Direction Horizontal AIR Flow Direction Adjusting the AIR Flow DirectionPress the Swing button Vertical airflow louvre will swingSpot AIR Coanda AirflowDuring operation, press the Coanda Airflow button Press the Coanda Airflow button againDuring operation, press the Full Power button Full Power Operation Energy Saving OperationPress the Full Power button again Press the Energy Save button againPress the 1.2.3.5h OFF Timer button to set the desired time Timer OperationTimer OFF Press the Timer OFF ButtonTo Cancel Timer Mode Timer onTo Change Time Setting Combined USE of on and OFF TimersPress the Self Clean button when the unit is not operating Plasmacluster Operation Self Clean OperationPress the Self Clean button During operation, press the Plasmacluster buttonVacancy Operation Operating Temperature RangeAdditional Notes on Operation Press the Heat button Press the Vacancy buttonMaintenance Specifications Before Calling for ServiceCheck the following points before calling for service Following conditions do not denote equip- ment malfunctionsPage