BEFORE CALLING FOR SERVICE
The following conditions do not denote equip- ment malfunctions
UNIT DOES NOT OPERATE
The unit will not operate if it is turned on immediately after it is turned off. The unit will not operate immediately after the mode is changed. This is to protect the unit. Wait 3 minutes before operating the unit.
UNIT DOES NOT SEND OUT WARM AIR
The unit is preheating or
ODORS
Carpet and furniture odors that entered into the unit may be recirculated by the unit.
CRACKING NOISE
This sound is generated by the friction of the unit expanding or connecting due to a temperature change.
A LOW BUZZING NOISE
This is a sound of the unit generating Plasmacluster ions.
SWISHING NOISE
The soft, swishing noise is the sound of the refrigerant flowing inside the unit.
MIST SEEN AT INDOOR AIR OUTLET
In cooling operation, this is caused by the difference between the room air temperature and the air discharged.
WATER VAPOUR
In heating operation, water vapour may flow out of the outdoor unit during
THE OUTDOOR UNIT DOES NOT STOP
After stopping the operation, the outdoor unit will rotate its fan for about a minute to cool down the unit.
ODOR EMITTED FROM THE PLASMACLUSTER AIR OUTLET
This is the smell of ozone generated from the Plasmacluster Ion generator. The ozone concentration is very small, posing no adverse effect on your health. The ozone discharged into the air rapidly decomposes, and its density in the room will not increase.
Check the following points before calling for service.
IF THE UNIT FAILS TO OPERATE
Check if the circuit breaker has tripped or the fuse has blown.
IF THE UNIT FAILS TO HEAT (OR COOL) THE ROOM EFFECTIVELY
•Check the filters. If dirty, clean them.
•Check the outdoor unit to make sure nothing is blocking the air inlet or outlet.
•Check the thermostat is properly set.
•Make sure windows and doors are closed tightly.
IF THE UNIT FAILS TO RECEIVE THE REMOTE CONTROL SIGNAL
•Check whether the remote control batteries have become old and weak.
•Try to send the signal again with the remote control pointed properly towards the unit’s signal receiver window.
•Check whether the remote control batteries are installed properly.
Please call for service when OPERATION lamp, TIMER lamp and/or PLASMACLUSTER lamp on the unit blink.
SPECIFICATIONS
Indoor unit |
| ||
Outdoor unit |
|
| |
Rated A.C. voltage (V) | |||
Rated frequency (Hz) | 50 | ||
Capacity (kW) | Cooling | 3.6 | |
Heating | 4.8 | ||
| |||
Rated input (W) | Cooling | 990 | |
Heating | 1260 | ||
| |||
When tested in accordance with AS/NZS3823.1.1
15